Installation Instructions

FormNo.3397-475RevA

WindowGuardKit

2015andAfterReelmaster

7000-DTractionUnitwithCab

ModelNo.132-3295

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Guardassembly

2Installtheguards.

InstallingtheGuards

1.Parkthemachineonlevelground,lowerthemower

decks,settheparkingbrake,stoptheengine,and

removethekey.

2.On1sideofthecab,loosen,butdonotremove,the3

angenutsandthe3boltssecuringthebottomfront

windowtotheframeofthecab(Figure1).

Figure1

1.Flangenut3.Bolts

2.Washer(3)4.Shoulderbolt

3.Whileholdingtheglassinplace,removethe3nuts,the

3bolts,andthe3washers.

Note:Retainthenutsandboltsanddiscardthe

washers.

4.Whilestillholdingtheglassinplace,alignaguard

assemblyovertheglass(Figure2).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3397-475*A

PAGE 1
Form No. 3397-475 Rev A Window Guard Kit 2015 and After Reelmaster® 7000-D Traction Unit with Cab Model No. 132-3295 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
Note: Ensure that the rubber grommets remain in place. CAUTION The sharp edges of the mesh guard could cut you or someone else. Keep the cable ties in place on the guard frames until the guards are secured with the nuts and bolts. Figure 2 1. Flange nut 4. Cable tie (2) 2. Bolt 3. Guard assembly 5. Shoulder bolt 5. Secure the bottom front corner of the glass and the guard with the shoulder bolt and a flange nut (Figure 2). 6. Secure the other 2 corners with 2 flange nuts and 2 bolts (Figure 2). 7.