Installation Instructions

FormNo.3402-990RevA

QuickAttachKit

GrandStand

MultiForceMower

ModelNo.132-5193

InstallationInstructions

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Quick-attachassembly

1Installthekit.

Nopartsrequired

–

Installanattachment.

InstallingtheKit

1.Shutofftheengine,waitforallmovingpartstostop,

engagetheparkingbrake,andremovethekey.

2.Ifdesired,removethemowerdeck;refertothe

Operator’sManualforthemachine.

3.Removethehairpincotterandthenthehitchpinfrom

theaccessoryframe(Figure1).

Figure1

1.Hairpincotter3.Hitchpin

2.Accessoryframe

4.Removethehairpincotterandattachpinfromthe

quick-attachassembly(Figure2).

Figure2

1.Attachpin2.Hairpincotter

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3402-990*A

PAGE 1
Form No. 3402-990 Rev A Quick Attach Kit GrandStand® Multi Force Mower Model No. 132-5193 Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
Installing an Attachment 5. Slide the end of the quick-attach assembly inside the accessory frame (Figure 3). 1. Pull back the attach pin and rotate it counter-clockwise to unlock the quick-attach assembly (Figure 5). Figure 3 1. Quick-attach assembly 2. Accessory frame 6. Install the attach pin and hairpin cotter of the quick-attach assembly (Figure 4). Figure 5 1. Attachment mount 3. Attach pin 2. Quick-attach assembly 2. Slide the attachment mount over the quick-attach assembly (Figure 5). 3.