Installation Instructions

FormNo.3396-562RevA

LEDLampKit

Greensmaster

3000SeriesTractionUnitwithLightKit

ModelNo.132-6960

InstallationInstructions

Note:ThiskitreplacesstandardlightswithLEDlights.Alightkitmustalreadybeinstalledonthemachine.

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

InstallingtheKit

1.Parkthemachineonalevelsurface,turnofftheengine,

andremovethekey.

CAUTION

Ifyouleavethekeyintheignitionswitch,

someonecouldaccidentlystarttheengineand

seriouslyinjureyouorbystanders.

Removethekeyfromtheignitionswitch

beforeyoudoanymaintenance.

2.Disconnectthenegative(-)batterycablefromthe

battery.

3.Disconnecttheexistinglampfromthewiringharness.

4.Removetheexistingcarriagebolt,nut,andlampfrom

thesupportbracket(Figure1).

Figure1

1.Lamp

3.Supportbracket

2.Carriagebolt

4.Nut

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3396-562*A

PAGE 1
Form No. 3396-562 Rev A LED Lamp Kit Greensmaster® 3000 Series Traction Unit with Light Kit Model No. 132-6960 Installation Instructions Note: This kit replaces standard lights with LED lights. A light kit must already be installed on the machine. WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installing the Kit 1.
PAGE 2
5. Install the LED lamp to the support bracket using a carriage bolt, lockwasher, and nut (Figure 2). 6. Connect the kit wiring harness to the LED lamp (Figure 3). Figure 3 1. Kit wiring harness 2. Existing wiring harness Figure 2 1. Carriage bolt 3. Lockwasher 2. LED lamp 4. Nut 7. Connect the kit wiring harness to the existing wiring harness (Figure 3). 8. Connect the negative battery cable to the battery. 9. Turn on the lights and adjust each light as necessary.