Installation Instructions

FormNo.3404-219RevA

WeightBracketKit

Groundsmaster

7200SeriesMowerwithPolarTrac

Cab

ModelNo.132-8170

ModelNo.132-8174

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Leftweightbracket

Rightweightbracket1

Weightlock2

Flangenut(3/8inch)

Carriagebolt(1/2x1-1/2inches)

Locknut(1/2inch)

InstalltheweightbracketforaTorocab.

Leftweightbracket

Rightweightbracket1

Weightlock2

Flangenut(3/8inch)

Carriagebolt(1/2x3inches)

Carriagebolt(1/2x3-1/2inches)

Locknut(1/2inch)

Washer2

Installtheweightbrackets.

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3404-219*A

PAGE 1
Form No. 3404-219 Rev A Weight Bracket Kit Groundsmaster® 7200 Series Mower with Polar Trac® Cab Model No. 132-8170 Model No. 132-8174 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 Description Qty.
PAGE 2
1 Installing the Weight Brackets for Polar Track Cab 2015 and After Cabs Parts needed for this procedure: Figure 2 1 Left weight bracket 1 Right weight bracket 1. Locknut (1/2 inch) 4. Flange nut (3/8 inch) 2 Weight lock 2. Weight lock 5. Carriage bolt (1/2 x 1-1/2 inches) 4 Flange nut (3/8 inch) 3. Right weight bracket 6. Left weight bracket 5 Carriage bolt (1/2 x 1-1/2 inches) 5 Locknut (1/2 inch) Procedure 1. Mark the location and drill the holes into the cab as shown in Figure 1.
PAGE 3
2 Installing the Weight Brackets for Polar Track Cab 2014 and Before Cabs Parts needed for this procedure: 1 Left weight bracket 1 Right weight bracket 2 Weight lock 4 g035367 Figure 4 1. Left weight bracket 5. Carriage bolt (1/2 x 3-1/2 inches) Flange nut (3/8 inch) 2. Carriage bolt (1/2 x 3 inches) 6. Right weight bracket 2 Carriage bolt (1/2 x 3 inches) 3. Washer 7. Flange nut (3/8 inch) 2 Carriage bolt (1/2 x 3-1/2 inches) 4. Weight lock 8.
PAGE 4