Installation Instructions

ManualsBrandsToro ManualsAttachmentsUltra Sonic Boom Finishing Kit, 2013 and After Multi Pro WM Turf Sprayer

FormNo.3404-503RevA

UltraSonicBoom

™

FinishingKit

2013andAfterMultiPro

WMTurfSprayer

ModelNo.133-2808

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

UseofthisproductmaycauseexposuretochemicalsknowntotheStateofCalifornia

tocausecancer,birthdefects,orotherreproductiveharm.

ThisproductcomplieswithallrelevantEuropeandirectives.Fordetails,pleaseseetheseparateproductspecicDeclarationof

Incorporation(DOI)sheet.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3404-503*A

Summary of content (16 pages)

PAGE 1
Form No. 3404-503 Rev A Ultra Sonic Boom™ Finishing Kit 2013 and After Multi Pro® WM Turf Sprayer Model No. 133-2808 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
PAGE 2
Installation Important: You will install this kit while installing the Ultra Sonic Boom Leveling Kit. Note: Determine the left and right sides of the machine from the normal operating position. Preparing the Machine 1. Squeeze the sides of the battery cover to release the tabs from the slots in the battery base, and remove the battery cover from the battery base (Figure 2).
PAGE 3
Routing the Rear Wire Harness 3
PAGE 4
PAGE 5
PAGE 6
Routing the Front Wire Harness Removing the Control Panel Figure 7 6
PAGE 7
Routing the Front Wire Harness and Connecting the Wire Harness Electrical Connectors Harness description Connector description Label Front wire harness—ultra sonic boom finishing kit 4-socket SPLIT HARNESS CONNECTOR Rear wire harness—ultra sonic boom finishing kit 4-pin SPLIT HARNESS CONNECTOR Front wire harness—ultra sonic boom finishing kit 12-socket SPLIT HARNESS CONNECTOR Rear wire harness—ultra sonic boom finishing kit 12-pin SPLIT HARNESS CONNECTOR 7
PAGE 8
Important: You will connect the electrical connectors routed to the center console when installing the ultra sonic boom leveling kit.
PAGE 9
Installing the Fuse Block and Connecting the Power Circuit Harness description Connector description Label Front wire harness—ultra sonic boom finishing kit 1-blade insulated TO FUSE BLOCK EXPANSION CONN.
PAGE 10
Important: You will install the hood when installing the ultra sonic boom leveling kit.
PAGE 11
Assembling the Ring Terminal to the Positive Battery Cable Important: You will connect the positive battery cable to the battery when installing the ultra sonic boom leveling kit.
PAGE 12
Replacing the Lift-Manifold Bracket Remove the Lift-Manifold Bracket 12
PAGE 13
Installing the Lift Manifold Bracket and Cover Ultra Sonic Boom Leveling Kit—Lift Manifold 13
PAGE 14
Important: You will install the cover for the electronic control unit when installing the ultra sonic boom leveling kit.
PAGE 15
Notes: 15
PAGE 16