Installation Instructions

ManualsBrandsToro ManualsRiding ProductsMulching Kit, ProLine H800 Rotary Mower

FormNo.3437-543RevA

MulchingKit

ProLineH800RotaryMower

ModelNo.134-1718

InstallationInstructions

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

Installation

PreparingtheMachine

NoPartsRequired

Procedure

1.Rotatethecuttingunitintothemaintenance

position;refertoyourmachineOperator’s

Manual.

2.Thoroughlycleanthecuttingunit.Removeall

debristoensurethatthebafestproperly

againstthecuttingunit.

RemovingtheExisting

Wing-BladeAssemblies

NoPartsRequired

Procedure

1.Removetheexistingwing-bladeassemblies;

refertothemower-deckmaintenancesectionin

yourmachineOperator’sManual.

Setasidethebolts,springlockwashers,

andcurvedwashersforthemulching-blade

installationprocedure.

Important:Theright-bladeassemblybolt

hasaleft-handedthread.Turnthebladebolt

clockwisetoloosenit.

2.Savetheexistingwing-bladeassembliesforuse

whenyouusethehopperforcollection.

Installingthe

Discharge-ChutePlug

Partsneededforthisprocedure:

1Discharge-chuteplug

1Bolt

1Washer

1Nut

Procedure

1.Useabolt,washer,andnuttoinstallthe

discharge-chuteplugoverthedisharge-chute

opening(Figure1).

Ifthereisnotaholeinthebafe,usetheholein

theplugtodrilla9.5mm(0.375inch)holeinthe

bafe.Removeanybursfromthehole.

g314525

Figure1

1.Nut3.Bolt

2.Washer4.Plug

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3437-543*A

Summary of content (2 pages)

PAGE 1
Form No. 3437-543 Rev A Mulching Kit ProLine H800 Rotary Mower Model No. 134-1718 Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. 3 Installation 1 Preparing the Machine Installing the Discharge-Chute Plug Parts needed for this procedure: No Parts Required Procedure 1. Rotate the cutting unit into the maintenance position; refer to your machine Operator’s Manual. 2. Thoroughly clean the cutting unit.
PAGE 2
. Torque the bolt to 28 N∙m (21 ft-lb). 4 Installing the Mulching Blades Parts needed for this procedure: 1 Blade assembly (right side) 1 Blade assembly (left side) 2 Spacer Procedure 1. Hold a blade-assembly end using a cloth or a thickly-padded glove. 2. Use the previously-removed parts from the wing-blade-assembly removal procedure (bolts, spring lock washers, and curved washers) and spacers to install the blade assemblies to their respective sides (Figure 2). g314524 Figure 2 1. Bolt 2.