Installation Instructions

FormNo.3410-901RevA

BallastKit

Groundsmaster

3500,4500,or4700Series27inCuttingUnits

ModelNo.136-2881

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Safety

SafetyandInstructionalDecals

Safetydecalsandinstructionsareeasilyvisibletotheoperatorandarelocatednearanyareaofpotential

damage.Replaceanydecalthatisdamagedormissing.

decal121-3627

121–3627

1.Height-of-cutsettings

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3410-901*A

PAGE 1
Form No. 3410-901 Rev A Ballast Kit Groundsmaster® 3500, 4500, or 4700 Series 27in Cutting Units Model No. 136-2881 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential damage.
PAGE 2
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Ballast plate Slotted screw Flange nut Height-of-cut decal 8 2 2 1 Install the ballast plates. Installing the Ballast Plates Important: The ballast kit should be installed only when the UHMW front roller wheels are installed on the cutting unit. If you choose to install the cast iron roller wheels, the ballast kit should be removed from the cutting deck. 1.