Installation Instructions

ManualsBrandsToro ManualsRiding ProductsBallast Kit, Groundsmaster 4300-D Traction Unit

FormNo.3415-543RevA

BallastKit

Groundsmaster

4300-DTractionUnit

ModelNo.136-2915

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Ballastplate4

Carriagescrew

Rubberbumper1

Self-tappingscrew

Installtheballastplates.

PreparingtheMachine

NoPartsRequired

Procedure

Note:Youcanuseahoistforbetteraccessunder

themachine.

1.Parkthemachineonalevelsurfaceandengage

theparkingbrake.

2.Shutoffthecuttingunitsandensurethatthe

tractionpedalisintheNEUTRALposition.

3.Shutofftheengineandremovethekey.

InstallingtheBallastPlates

Partsneededforthisprocedure:

4Ballastplate

Carriagescrew

1Rubberbumper

Self-tappingscrew

Procedure

1.Removetheexistinghardwarefromthefrontof

themowerdeck(Figure1).Retainthenutsfor

laterinstallation.

Note:Youmaydiscardtheremovedcarriage

screws.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3415-543*A

Summary of content (4 pages)

PAGE 1
Form No. 3415-543 Rev A Ballast Kit Groundsmaster® 4300-D Traction Unit Model No. 136-2915 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine. 2 Ballast plate Carriage screw Rubber bumper Self-tapping screw 4 2 1 1 Install the ballast plates.
PAGE 2
Important: For the rear-center decks beneath the machine, complete the following steps to avoid contacting the hoses with the ballast weights. 3. Install the rubber bumper to the side of the ballast plate closest to the center of the machine with the self-tapping screw (Figure 3). Note: There is a hole started on the ballast plate to make installing the self-tapping screw easier and to show the proper location for installing the bumper. g215110 Figure 1 1. Nuts 2. Short carriage bolts 2.
PAGE 3
g215165 Figure 4 Center-right rear deck — Deck frame not shown for clarity 1. Standard hose routing 3. Self-tapping screw 2. R-clamp 4. Rubber bumper 5. Align the R-clamp perpendicular to the lift cylinder tube-arm and install the hoses so that they are pushed up from the ballast plates (Figure 5). Install the R-clamp with the self-tapping screw removed in step 4. g215177 Figure 5 Center-right rear deck — Deck frame not shown for clarity 1. New hose routing 3. Self-tapping screw 2. R-clamp 4.
PAGE 4