Installation Instructions

ManualsBrandsToro ManualsRiding ProductsHigh Height-of-Cut Turf Evaluator Kit

FormNo.3446-926RevA

HighHeight-of-CutTurfEvaluatorKit

ModelNo.136-3635

InstallationInstructions

Safety

SafetyandInstructionalDecals

decal136-3631

136-3631

1.Heightofcut(inches/millimeters)

Installation

Thisisaturf-heightevaluatorgaugeintendedforgrassheightswitha2.54to15.24cm(1to6inch)height.

Youcanusetheevaluatorgaugeforthefollowing:

•Forcommunicatingandevaluatingturf-height

conditions

•Troubleshootingquality-of-cutissues

•Todetermineamower'seffectiveheightofcut

•Calibratingmultiplemowerstohavematching

effectivecutheights

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3446-926*

Summary of content (4 pages)

PAGE 1
Form No. 3446-926 Rev A High Height-of-Cut Turf Evaluator Kit Model No. 136-3635 Installation Instructions Safety Safety and Instructional Decals decal136-3631 136-3631 1. Height of cut (inches/millimeters) Installation This is a turf-height evaluator gauge intended for grass heights with a 2.54 to 15.24 cm (1 to 6 inch) height.
PAGE 2
1 Mounting the Spikes No Parts Required Procedure 1. Remove the spikes from the storage position. 2. Install the spikes into the operating position. Note: If you desire to tighten the spikes, use a 1/4-inch wrench on the flat areas of the spikes. The spikes do not need to be tightened to obtain an accurate height-of-cut reading. g356697 Figure 1 2 1. Spikes in storage position 3. Spikes in operating position 2. Flat area for tightening the spikes 4.
PAGE 3
Operation Understanding the Terms • HOC: Height of cut • Nominal height-of-cut setting: The height position shown on the height-of-cut decal for the mower. • Bench height-of-cut setting: g356699 Figure 3 – This is the actual measurement from the mower blade tip to the floor at the 12 o'clock position. 1. 6.4 mm (1/4 inch) increments 2. White space for recording notes – Bench height-of-cut setting will likely differ slightly from the nominal height-of-cut shown on the height-of-cut decal on the mower.
PAGE 4
Bench height-of-cut setting (X) – effective height of cut (Y) = Difference in height of cut (X - Y = Z) 5. To achieve the intended effective height of cut, adjust the bench height-of-cut setting (X) by the difference (Z) and measure the turf again. The following is an example: The effective height of cut needed on a football field is 51 mm (2 inch) (X). The cutting unit height is set to a bench height-of-cut setting of 51 mm (2 inch).