Installation Instructions

ManualsBrandsToro ManualsTrenchersToro 136-5456

FormNo.3424-803RevA

TransmissionFilterfortheRT1200TractionUnit

ModelNo.136-5456

InstallationInstructions

Transmission-oilspecication:Mobiluid424

CheckingtheTransmission-OilLevel

Important:Ifyouoperatethemachinewhilethelevelofthetransmissionoilisbelowtherecommended

level,youmaydamagethetransmissionandtheparkingbrake.

1.Parkthemachineonalevelsurface.

2.Starttheengineandrunitfor10minutes.

3.Stoptheengineandremovetheignitionkey.

4.After5minutes,checkthetransmissionoillevelinthesightgauge(Figure1).

Note:Theoillevelshouldcover1/2to3/4ofthesight-gaugewindow.

g024954

Figure1

1.Sightgauge

5.Iftheoillevelislow,addthespeciedoilintothetransmission;refertoFillingtheTransmissionwith

Oil(page2).

6.Repeatsteps2through5untiltheoillevelcovers1/2to3/4ofthesight-gaugewindow(Figure1).

Note:Asyouaddoiltothetransmission,performsteps2through4todeterminethecorrectedoillevel.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3424-803*A

Summary of content (4 pages)

PAGE 1
Form No. 3424-803 Rev A Transmission Filter for the RT1200 Traction Unit Model No. 136-5456 Installation Instructions Transmission-oil specification: Mobilfluid 424 Checking the Transmission-Oil Level Important: If you operate the machine while the level of the transmission oil is below the recommended level, you may damage the transmission and the parking brake. 1. Park the machine on a level surface. 2. Start the engine and run it for 10 minutes. 3. Stop the engine and remove the ignition key.
PAGE 2
Changing the Transmission Oil Draining the Transmission Oil Note: If possible, drain the oil when it is warm. 1. Park the machine on a level surface, stop the engine, and remove the key. 2. Place a drain pan under the forward hole in the transmission shield (Figure 2). g024956 Figure 2 1. Transmission shield 3. Drain plug 2. Drain pan 3. Through the transmission shield, clean the area around the transmission drain plug (Figure 2). 4.
PAGE 3
g024955 Figure 3 3. Fill plug 1. Oil-servicing equipment 2. Fill port 5. Install the fill plug into the fill port securely 6. Start the engine and run it for 10 minutes. 7. Stop the engine and remove the key. 8. After 5 minutes, check the oil level in the sight gauge. Note: The oil level should cover 1/2 to 3/4 of the sight-gauge window (Figure 1). Note: As you add oil to the transmission, perform steps 6 through 8 to determine corrected oil level.
PAGE 4
Changing the Transmission Filter Note: You can access the transmission filter from underneath the right side of the machine, inboard of the hydraulic tank. 1. Place a drain pan under the transmission-oil filter (Figure 4). g024962 Figure 4 1. Forward 3. Sharp object 2. Transmission-oil filter 4. Drain pan 2. Puncture the bottom of the transmission filter, and allow the residual hydraulic fluid to drain into the drain pan (Figure 4).