Installation Instructions

FormNo.3410-320RevB

RearWheelKit

21inHeavy-DutyRecycler

/RearBaggerLawnMower,Models

22290,22291,22293,22295,22296,22297,and22298

ModelNo.136-5850

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCalifornia

tocausecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Wheelassembly1

Wheelcover1

Bolt(5/16x3/4inch)

Installtherearwheel.

PreparingtheMachine

1.Movethemachinetoalevelsurface(AofFigure

1).

2.Releasetheblade-controlbar(BofFigure1).

3.Disconnectthespark-plugwirefromthespark

plug(CofFigure1).

g189830

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3410-320*B

PAGE 1
Form No. 3410-320 Rev B Rear Wheel Kit 21in Heavy-Duty Recycler®/Rear Bagger Lawn Mower, Models 22290, 22291, 22293, 22295, 22296, 22297, and 22298 Model No. 136-5850 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
Removing the Rear Wheel 1. Loosen and remove the nut from the axle bolt; set the nut aside (Figure 2). g187972 Figure 4 1. Bolt (5/16 x 3/4 inch) 2. Retainer g187971 Figure 2 1. Nut 2. Wheel 2. 3. Axle bolt Remove the wheel assembly, spacer, and wheel cover (Figure 3). Important: Retain the spacer for use explained later in this procedure. g234379 Figure 3 1. Wheel assembly 3. Wheel cover 2. Spacer 3. Remove the bolt from the retainer and discard it (Figure 4). 2 3.
PAGE 3
Installing the Rear Wheel 1. 2. Apply anti-seize to the wheel gear teeth (Figure 6). Clean the pinion gear (Figure 5). Important: Inspect the pinion gear for wear; replace it if necessary. A worn pinion gear will cause premature wear on the wheel gear. g189234 Figure 6 1. Wheel gear teeth g189235 Figure 5 1. Pinion gear 3 3. Use the bolt (5/16 x 3/4 inch) to secure the retainer to the height-of-cut lever (Figure 4). 4. Torque the bolt to 20 to 23 N∙m (15 to 16 ft-lb). 5.
PAGE 4