Installation Instructions

Table Of Contents

FormNo.3413-435RevA

SeatBaseSealKit

Workman

HDorHDXSeriesUtilityVehicle

ModelNo.136-6321

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Sealstrip

Rubberseal2

Torx-headscrew(1/4x7/8inch)

Installtheseatbasesealkit.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Shutofftheengineandremovethekey.

g038494

Figure1

InstallingtheSeatBase

SealKit

1.Raisethefrontofthemachineusinganoverheadhoist.

2.UsingthemeasurementsshowninFigure2,drill3

holes(9.5mmor3/8inch)asclosetothebendinthe

ooraspossible.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3413-435*A

PAGE 1
Form No. 3413-435 Rev A Seat Base Seal Kit Workman® HD or HDX Series Utility Vehicle Model No. 136-6321 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine.
PAGE 2
g206085 Figure 2 1. 29.2 cm (11-1/2 inches) 3. Edge of the flange in the floor 2. 17.
PAGE 3
. Remove the existing rubber bumper from each side of the floor plate (Figure 3). g206208 Figure 5 Wheel and seat base removed for clarity 1. Edge of a seal strip aligned with the edge/flange of the floor plate g206128 Figure 3 Wheel removed for clarity 1. Floor plate 8. Mark the 4 hole locations on each side of the seat base. 2. Rubber bumper 9. Using a seal strip as a template, drill 4 holes (5.
PAGE 4