Installation Instructions

ManualsBrandsToro ManualsVehiclesWireless Hour Meter Kit, Workman GTX Utility Vehicle

FormNo.3413-421RevA

WirelessHourMeterKit

Workman

GTXUtilityVehicle

ModelNo.136-6323

ModelNo.136-6324

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Wirelesshourmeterwireharness1

Installthewirelesshourmeter(forgasolinemachines).

Wirelesshourmeterwireharness1

Relay(48V)

Screw(#4x3/4inch)

Installthewirelesshourmeter(forelectricmachines).

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Shutofftheengineandremovethekey.

g038447

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3413-421*A

Summary of content (4 pages)

PAGE 1
Form No. 3413-421 Rev A Wireless Hour Meter Kit Workman® GTX Utility Vehicle Model No. 136-6323 Model No. 136-6324 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine.
PAGE 2
Installing the Wireless Hour Meter (for Gasoline Machines) 1. Disconnect the existing female 2-socket connector from the existing hour meter and plug it into the male 2-pin connector on the wireless hour meter wire harness (Figure 2 and Figure 3). g206423 Figure 3 g205528 Figure 2 1. Existing hour meter 2. Existing female 2-socket connector 2. Connect the female 2-socket connector on the wireless hour meter wire harness to the existing hour meter (Figure 3). 3.
PAGE 3
Installing the Wireless Hour Meter (for Electric Machines) 4. Connect the female 4-socket connector on the wireless hour meter wire harness to the male 4-pin connector on the existing 12 V converter (Figure 6). 1. Disconnect the existing female 2-socket connector from the existing hour meter and plug it into the male 2-pin connector on the wireless hour meter wire harness (Figure 4 and Figure 5). g205607 Figure 6 1. 12 V converter 3. 4-socket connector (wireless hour meter wire harness) 2.
PAGE 4
6. Install the relay to the left fender using 2 screws (#4 x 3/4 inch) as shown in Figure 8. g205529 Figure 8 1. Screw (#4 x 3/4 inch) 3. Left fender 2. Relay 7. Connect the wireless hour meter wire harness connectors to the relay as shown in Figure 9. g205526 Figure 9 1. Pink wire 2. White wire 3.