Installation Instructions

ManualsBrandsToro ManualsLawn MowersToro 136-7000

FormNo.3408-237RevA

BrakeCableKit

21inHeavy-DutyRecycler

/RearBaggerLawnMower

ModelNo.133-2680

ModelNo.136-7000

InstallationInstructions

Usetheappropriatekitforyourlawnmowermodelasfollows:

•Lawnmowermodelno.22295—kitno.133-2680

•Lawnmowermodelno.22297—kitno.136-7000

WARNING

CALIFORNIA

Proposition65Warning

Thisproductcontainsachemicalorchemicals

knowntotheStateofCaliforniatocausecancer,

birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Brakecable1

Cableanchor

Screw

Installthebrakecable.

RemovingtheBrakeCable

NoPartsRequired

Procedure

1.Shutofftheengineandwaitforallmovingpartsto

stop.

2.Disconnectthespark-plugwirefromthesparkplug.

3.Disconnectthebrakecablefromtheblade-controlbar

(Figure1orFigure2asappropriateforyourkit);keep

theboltandthenut.

g187498

Figure1

Kit133-2680

1.Bolt(keep)3.Cableanchor

2.Screw(discard)4.Nut(keep)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3408-237*A

Summary of content (4 pages)

PAGE 1
Form No. 3408-237 Rev A Brake Cable Kit 21in Heavy-Duty Recycler®/Rear Bagger Lawn Mower Model No. 133-2680 Model No. 136-7000 Installation Instructions Use the appropriate kit for your lawn mower model as follows: • Lawn mower model no. 22295—kit no. 133-2680 • Lawn mower model no. 22297—kit no. 136-7000 WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
PAGE 2
g187414 Figure 2 Kit 136-7000 1. Bolt (keep) 3. Cable anchor 2. Screw (discard) 4. Nut (keep) 4. Disconnect the brake cable from the cable anchor (Figure 1 or Figure 2 as appropriate for your kit); discard the screw, but keep the nut. g187634 Figure 4 Kit 136-7000 5. Disconnect the brake cable from the engine (Figure 3 or Figure 4 as appropriate for your kit), then discard it. 1. Nut 2. Spacer g187780 Figure 3 Kit 133-2680 1. Brake cable 2. Engine connection location 2 3. Brake cable 4.
PAGE 3
Adjusting the Brake Cable 2 1. Hold the blade-control bar at 19 cm (7-5/8 inches) from the top of the handle as shown in Figure 6. Installing and Adjusting the Brake Cable Parts needed for this procedure: 1 Brake cable 1 Cable anchor 1 Screw Installing the Brake Cable g034988 Figure 6 Important: If you are installing this kit on a machine with serial numbers 400000000–999999999, skip steps 1 and 2. 1. Handle 2. Cable-anchor nut 1.
PAGE 4