Installation Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 136-8350

FormNo.3429-917RevA

FloatKit

GrandStand

MultiForceMowerorSnowMachine

ModelNo.136-8350

InstallationInstructions

Safety

SafetyandInstructional

Decals

Safetydecalsandinstructionsareeasilyvisibletotheoperatorandarelocatednearanyarea

ofpotentialdanger.Replaceanydecalthatisdamagedormissing.

decal136-5708

136-5708

1.Lower2.Float

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Switch

Wireharness1

Relay2

Decal1

Installthekit.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3429-917*A

Summary of content (4 pages)

PAGE 1
Form No. 3429-917 Rev A Float Kit GrandStand® Multi Force Mower or Snow Machine Model No. 136-8350 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal136-5708 136-5708 1. Lower 2. Float Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty.
PAGE 2
1 Preparing the Machine No Parts Required Procedure 1. Park the machine on a level surface. 2. Disengage the PTO, engage the parking brake, and move the motion-control levers outward to the NEUTRAL-LOCK position. 3. Shut off the engine and remove the key. 4. Remove the negative (-) battery cable from the battery. g212536 Figure 1 1. 26 mm (1 inch) 3. 29 mm (1.1 inch) 2. Hole—12 mm (1/2 inch) diameter 3.
PAGE 3
4. 8. Connect the switch connector (P06) from the wire harness to the switch (Figure 3). Remove the diode from the Low Flow Kit wire harness, plug the controller harness connector (P03) into that connector, and plug the diode into the diode socket (P07) as shown in Figure 5. g214830 Figure 3 g214829 1. Wire harness 4. Relay 2. Switch connector (P06) 5. Relay connector (P05) 3. Switch 6. Relay connector (P04) 5. Install the 2 relays onto the relay connectors (P04 and P05) as shown in Figure 3.
PAGE 4
Operation Using the Float Switch Move the switch to the FLOAT position (Figure 7) and press the left switch on the low-flow controller to allow the attachment to follow the contour of the ground (Figure 8). Press the left switch on the low-flow controller rearward to disengage the float mode and raise the attachment off the ground. Move the float switch to the normal operating position to control the attachment using Low Flow Hydraulic Kit. g210832 Figure 7 1. Lower to normal operating position 2.