Installation Instructions

ManualsBrandsToro ManualsRiding ProductsLeak Detector Tank Kit, Greensmaster 3150 2-Wheel Drive Traction Unit

FormNo.3417-220RevA

LeakDetectorTankKit

Greensmaster

31502-WheelDriveTractionUnit

ModelNo.136-8547

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

Thisproductcontainsachemical

orchemicalsknowntotheStateof

Californiatocausecancer,birthdefects,

orreproductiveharm.

Installation

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Shutofftheengineandremovethekey.

4.Disconnectthebattery;refertoyourmachine

Operator’sManual.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3417-220*A

Summary of content (4 pages)

PAGE 1
Form No. 3417-220 Rev A Leak Detector Tank Kit Greensmaster® 3150 2-Wheel Drive Traction Unit Model No. 136-8547 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation 1 Preparing the Machine No Parts Required Procedure © 2017—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Register at www.Toro.com. 1.
PAGE 2
Removing the Leak Detector Tank No Parts Required Procedure WARNING Hydraulic fluid escaping under pressure can penetrate skin and cause injury. g225757 Figure 1 • Make sure that all hydraulic fluid hoses and lines are in good condition and all hydraulic connections and fittings are tight before applying pressure to the hydraulic system. 1. Pump inlet hose 2. Pump assembly 3. • Keep your body and hands away from pinhole leaks or nozzles that eject high-pressure hydraulic fluid.
PAGE 3
g225830 Figure 2 Hydraulic Tank System overview—Leak Detector Tank equipped 1. Hydraulic tank 10. Long cap screw (2) 19. Solenoid valve assembly 2. Hose clamp (2) 11. Straight barb fitting 20. Lock washer (2) 3. Straight barb fitting 12. Long spacer (2) 21. 90° barb fitting 4. Short spacer (2) 13. Kit leak detector tank 22. Tank valve hose 5. Neoprene washer (4) 14. Valve hose 23. Overflow hose 6. Canister bracket 15. Solenoid screw (2) 24. Carbon canister assembly 7.
PAGE 4
3 4 Installing the Leak Detector Completing the Installation Tank No Parts Required No Parts Required Procedure Procedure 1. Fill the hydraulic tank with the drained hydraulic fluid; refer to your machine Operator’s Manual. 1. Lubricate and place a new O-ring on the straight barb fitting removed in step 9. 2. 2. Install the straight barb fitting into the underside of the kit leak detector tank; tighten it to 23 to 28 N·m (17 to 21 ft-lb).