Installation Instructions

ManualsBrandsToro ManualsUtility VehicleToro 137-5226

FormNo.3415-957RevA

MudPumpTransducerRelocationKit

DD4045DirectionalDrill

ModelNo.137-5226

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCalifornia

tocausecancer,birthdefects,orreproductiveharm.

PreparingtheMachine

1.Movethemachinetoalevelsurface.

2.Shutofftheengineandremovethekey.

3.Setthebattery-disconnectswitchtotheOFFposition.

InstallingtheKit

LooseParts

1x1x1x

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3415-957*A

Summary of content (4 pages)

PAGE 1
Form No. 3415-957 Rev A Mud Pump Transducer Relocation Kit DD4045 Directional Drill Model No. 137-5226 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Preparing the Machine 1. Move the machine to a level surface. 2. Shut off the engine and remove the key. 3. Set the battery-disconnect switch to the OFF position.
PAGE 2
Disconnecting the Transducer g212364 Figure 1 1. Locate the transducer below the bulkhead, just above the fuel-tank sending unit (Figure 1). 2. Disconnect the wire harness from the transducer fitting (Box A of Figure 2). 3. Remove and save the transducer assembly and fitting currently installed (Box A of Figure 2). 4. Install the cap onto the port (Box B of Figure 2); torque to 79 to 98 N∙m (58 to 72 ft-lb). 5. Connect the existing harnesses to the new wire harness (Box C of Figure 2).
PAGE 3
Installing the Transducer g215620 Figure 3 1. Remove the hose from the fitting on the rear control weldment (Box A of Figure 4). g215621 Figure 4 2. Remove and save the fitting from the rear control weldment (Box B of Figure 4). 3. Install the tee fitting on the rear control weldment (Box C of Figure 4); torque the fitting to 301 to 336 N∙m (222 to 248 ft-lb). . 4. Install the hose onto the tee fitting (Box D of Figure 4). 5.
PAGE 4
8. Torque the transducer adapter to 79 to 98 N∙m (58 to 72 ft-lb) and the transducer to 46 to 57 N∙m (34 to 42 ft-lb). 9. Route the harness along the existing harnesses over to the transducer (Figure 6). Important: Do not route the wire harness near moving parts. g212417 Figure 6 10. Secure the harness using the cable ties (Figure 7).