Installation Instructions

FormNo.3422-333RevA

WingMountKit

Groundsmaster

4000SeriesRotaryMower

ModelNo.137-5580

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Deckmount1

Plate1

Springpin

Spacer

Bolt(3/4x4-1/2inches)

Locknut(3/4inch)

Cabletie

Installthekit.

Determinetheleftandrightsidesofthemachinefrom

thenormaloperatingposition.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Disengagethepowertakeoffandlowerthe

attachments.

3.Engagetheparkingbrake.

4.Shutofftheengineandremovethekey.

5.Waitforallmovementtostop.

6.Allowmachinecomponentstocool.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3422-333*

PAGE 1
Form No. 3422-333 Rev A Wing Mount Kit Groundsmaster® 4000 Series Rotary Mower Model No. 137-5580 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. Deck mount Plate Spring pin Spacer Bolt (3/4 x 4-1/2 inches) Locknut (3/4 inch) Cable tie 1 1 1 2 1 1 1 Install the kit. Determine the left and right sides of the machine from the normal operating position.
PAGE 2
Installing the Deck Mount 1. Remove the snap rings on both sides of the U-joint as shown in Figure 3. 2. Remove the caps under the snap rings. This can be done by adding more grease into the U-joint. 3. Remove the existing long bolt (Figure 3). 4. Remove the plate and rubber cushion (Figure 3). Discard the plate. 5. Remove the bolts that hold the deck mount to the cutting unit (Figure 3). 6. Remove the bolt, locknut, and spacers that secure the hydraulic cylinder to the deck mount.
PAGE 3
10. Install the U-joint caps and secure them with the previously removed snap rings (Figure 3). 11. Install the hydraulic cylinder to the deck mount with a bolt (3/4 x 4-1/2 inches), locknut (3/4 inch), and spacers (Figure 3); torque to 136 N∙m (100 ft-lb). 12. Install the cable tie (Figure 5). g365599 Figure 3 g365600 1. Spring pin 2. Snap ring 3. 4. 5. 6. Rubber cushion Plate Deck mount Locknut (3/4 inch) 7. Spacer Figure 5 8. Bolt (3/4 x 4-1/2 inches) 1. Cable tie 9. Bolt 10.
PAGE 4