Installation Instructions

ManualsBrandsToro ManualsRiding ProductsFront Light Mount Kit, Greensmaster TriFlex or eTriFlex Traction Unit

FormNo.3440-485RevA

FrontLightMountKit

Greensmaster

TriFlex

oreTriFlexTractionUnit

ModelNo.137-7947

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Rightlightmount1

Leftlightmount

Bolt4

Nut4

Installthelightmounts.

Nopartsrequired

–

Installthelightstothelightmounts.

Cabletie

10Routethewireharness.

PreparingtheMachine

NoPartsRequired

Procedure

Note:Thiskitincludesonlythefrontlightmounts;youwillneedtoorderthelightkit.Formoreinformation,

contactyourauthorizedTorodistributor.

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Lowerthecuttingunits.

4.Shutoffthemachineandremovethekey.

5.Disconnectthemain-powerconnectors;refertotheoperator’smanualforyourmachine.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3440-485*

Summary of content (4 pages)

PAGE 1
Form No. 3440-485 Rev A Front Light Mount Kit Greensmaster® TriFlex® or eTriFlex Traction Unit Model No. 137-7947 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine. 2 Right light mount Left light mount Bolt Nut 1 1 4 4 Install the light mounts. No parts required – Install the lights to the light mounts. Cable tie 10 Route the wire harness.
PAGE 2
Installing the Light Mounts Parts needed for this procedure: 1 Right light mount 1 Left light mount 4 Bolt 4 Nut Procedure Use the provided bolts and nuts to secure the brackets to the foot platform (Figure 1). g326409 Figure 1 1. Left light mount 3. Bolt 2. Nut 4.
PAGE 3
4 Installing the Light to the Light Mounts Routing the Wire Harness Parts needed for this procedure: 10 No Parts Required Procedure 1. Procedure If the front lights are on the roll bar, remove them from the roll bar. 1. Note: Retain all removed parts for later installation. 2. Cable tie If the wire harness was routed to the lights on the roll bar, remove the cable ties that secure the front light connections of the wire harness to the roll bar (Figure 3).
PAGE 4
3. 5. If the wire harness has not been installed for a previous light kit, route the light connections of the wire harness under the seat as shown in Figure 4. Route the light connections of the wire harness along the frame to the new light mounts (Figure 5). Note: You may route the rear light segment of the harness to the roll bar if you have a rear light. g353640 g353641 g353639 Figure 5 6.