Installation Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 137-9216

FormNo.3422-362RevA

BucketMountKit

ZMaster

3000,5000,or6000SeriesRidingMower

ModelNo.137-9216

InstallationInstructions

Safety

SafetyandInstructionalDecals

Safetydecalsandinstructionsareeasilyvisibletotheoperatorandarelocatednearanyarea

ofpotentialdanger.Replaceanydecalthatisdamagedormissing.

decal137-9231

137-9231

1.Maximumweight7kg(15lb)

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Bucket-holdermount1

Bracket-supporthinge1

Mountstrap—for48,52,and60-inchdecks

Mountstrap—for72-inchdecks

Topbracket1

Knob1

Carriagebolt(5/16x7/8inch)

Flangenut(5/16inch)

Flange-headbolt(3/8x1inch)

Locknut(3/8inch)

Installthekit.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3422-362*A

Summary of content (4 pages)

PAGE 1
Form No. 3422-362 Rev A Bucket Mount Kit Z Master® 3000, 5000, or 6000 Series Riding Mower Model No. 137-9216 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal137-9231 137-9231 1. Maximum weight 7 kg (15 lb) Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
Preparing the Machine 1. Park the machine on a level surface. 2. Move the motion-control levers to the NEUTRAL-LOCK position. 3. Engage the parking brake. 4. Shut off the engine and remove the key. g037289 Figure 1 Installing the Kit 1. Install the bucket-holder mount into the deck-mounting hole by the discharge plate (Figure 2). g253477 Figure 2 1. Bucket-holder mount 2.
PAGE 3
2. Secure the bracket-support hinge and mount strap to the bucket-holder mount using 3 carriage bolts (5/16 x 7/8 inch) and 3 flange nuts (5/16 inch) as shown in Figure 3. 3. Secure the mount strap to the mower deck using the flange-head bolt (3/8 x 1 inch) and locknut (3/8 inch) as shown in Figure 5. Refer to Figure 4 for the proper mount strap. Use the mount strap with the 51 mm (2 inches) bend offset and 4 holes for 48, 52, and 60-inch decks.
PAGE 4
Operation Mounting a Bucket Use only Toro-approved attachments and accessories. The maximum capacity is 7 kg (15 lb). 1. Loosen the knob and raise the top bracket. Tighten the knob to hold it in place (Figure 7). 2. Place the bottom lip of the bucket over the bottom ledge of the welded support bracket (Figure 7). 3. Loosen the knob and lower the top bracket as far as possible over the rim of the bucket. Tighten the knob (Figure 7). g253491 Figure 7 1. Top bracket over the rim of 3.