Installation Instructions

ManualsBrandsToro ManualsAttachmentsWireless Hour Meter Wire Harness Kit, Greensmaster 1000 Mower with Honda Engine

FormNo.3426-337RevA

WirelessHourMeterWireHarnessKit

Greensmaster

1000MowerwithHondaEngine

ModelNo.138-2147

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

WireHarness1

Bracket1

Regulator1

Bolt2

Cabletie

Installthekit.

WireHarnessConnections

Refertothetablebelowforthewireharnessconnectionsusingthewireharnesscolors.

WirelessHourMeterWireHarness

YellowBlue

BlackBlack

MachineWireHarness

Yellow

Green

BlackWhite

EngineWireHarness

InstallingtheKit

1.UnplugandremovetheDeltamoduleandunplugthepowerconnectionsfromthebackoftheengine.

2.Removethe2nutssecuringthefueltanktotheengine.

3.Removetheoldbracket.

4.Installthenewbracketandmachinewireharnessgroundwiththe2nutspreviouslyremoved.Installthe

Deltamoduleontothenewbracketusingthehardwarepreviouslyremoved(Figure1).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3426-337*A

Summary of content (4 pages)

PAGE 1
Form No. 3426-337 Rev A Wireless Hour Meter Wire Harness Kit Greensmaster® 1000 Mower with Honda Engine Model No. 138-2147 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Wire Harness Bracket Regulator Bolt Cable tie 1 1 1 2 6 Install the kit. Wire Harness Connections Refer to the table below for the wire harness connections using the wire harness colors.
PAGE 2
g285370 Figure 1 5. Install the wireless hour meter regulator to the new bracket (Figure 2) using the 2 bolts. Note: Ensure that the regulator ground terminal is installed under the bolt head. 6. Connect the bottom connector, of the wireless hour meter wire harness, to the wireless hour meter regulator. g285368 Figure 2 1. Wireless hour meter regulator ground terminal 2. Engine bolt 4. Bottom connector of the wire harness for the wireless hour meter 5. Bolt 3.
PAGE 3
8. Install the engine bolt. 9. Connect the other connectors to the machine and engine accessory connectors. Refer to Wire Harness Connections (page 1) and Figure 3. 10. Connect the power harness to the engine wire harness connector. g285369 Figure 3 1. Engine wire harness connector 2.
PAGE 4
11. Connect the top of the wire harness to the wireless hour meter (Figure 4). g285392 Figure 4 1. Connector to the wireless hour meter 2. Connectors to the engine wire harness 6. Bracket 7. Engine wire harness 3. Connectors to the machine 8. Accessory connectors 4. Connector to the wireless hour meter regulator 9. Wireless hour meter regulator 5. Wireless hour meter wire harness ground 12. Use cable ties to secure the wire harness to the handle and out of the way of hot or sharp parts.