Installation Instructions

ManualsBrandsToro ManualsRiding ProductsPower Harness Kit, Groundsmaster 3280-D 4-Wheel Drive Traction Unit

FormNo.3423-154RevA

PowerHarnessKit

Groundsmaster

3280-D4-WheelDriveTractionUnit

ModelNo.138-2998

InstallationInstructions

Installation

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Lowerthecuttingunits.

4.Shutofftheengineandremovethekey.

AccessingtheMachine

NoPartsRequired

OpeningtheHood

g198446

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3423-154*A

Summary of content (4 pages)

PAGE 1
Form No. 3423-154 Rev A Power Harness Kit Groundsmaster® 3280-D 4-Wheel Drive Traction Unit Model No. 138-2998 Installation Instructions 2 Installation 1 Accessing the Machine Preparing the Machine No Parts Required Opening the Hood No Parts Required Procedure 1. Park the machine on a level surface. 2. Engage the parking brake. 3. Lower the cutting units. 4. Shut off the engine and remove the key.
PAGE 2
3 Removing the Battery Cables No Parts Required Procedure WARNING Battery terminals or metal tools could short against metal components, causing sparks. g253131 • When removing or installing the battery, do not allow the battery terminals to touch any metal parts of the machine. Figure 2 1. Negative battery cable • Do not allow metal tools to short between the battery terminals and metal parts of the machine. 2. • Always keep the battery strap in place to protect and secure the battery.
PAGE 3
Connecting the Washer Bottle 4 1. Connect the plug into the washer bottle (Figure 4). Routing the Wire Harness No Parts Required Installing the Wire Harness Important: Whenever working with the electrical system, always disconnect the battery cables, black (-) cable first, to prevent possible wiring damage from short-outs. 1. Route the wire harness on the right side of the machine frame (Figure 3). g032522 Figure 4 1. Washer connector 2. 2.
PAGE 4
g032519 Figure 5 1. Positive-post clamp 4. Ring connector 2. Negative-post clamp 5. Bolt 3. Nut 3. Remove the nuts from the post bolts (Figure 5). 4. Install the positive-terminal connector (red wire) over the positive-post bolt and loosely install the nut (Figure 5). 5. Install the negative-terminal connector (black wire) over the negative-post bolt and loosely install the nut (Figure 5). 6.