Installation Instructions

ManualsBrandsToro ManualsUtility VehicleToro 138-4320

Table Of Contents

.
- 1 Installing the Lift Frame

FormNo.3418-253RevA

BRC-28LiftFrameKit

ModelNo.138-4320

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Liftframe

Sidemountbolt

Locknut4

Frontmountingbolt2

Frontmountblock1

Liftingeye

Flatwasher2

Lockwasher1

Lifting-eyebolt

Installtheliftframe.

InstallingtheLiftFrame

Partsneededforthisprocedure:

Liftframe

Sidemountbolt

4Locknut

2Frontmountingbolt

1Frontmountblock

Liftingeye

2Flatwasher

1Lockwasher

Lifting-eyebolt

Procedure

Note:Discardanyremovedhardwareunless

otherwisedirected.

1.Parkonalevelsurface,shutofftheengine,and

removethekey.

2.Bendtheupperportionsofthetie-downsections

onthehandlesupportbracessothattheyare

nearlyvertical(Figure1).

g242155

Figure1

Leftsideshown

1.Tie-down4.Handlesupportbrace

2.Uppernuts5.Bolts

3.Nuts(insidechassis)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedinAustralia

AllRightsReserved

*3418-253*A

PRELIMINARY

Summary of content (4 pages)

PAGE 1
Form No. 3418-253 Rev A BRC-28 Lift Frame Kit Model No. 138-4320 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 Description 1 4 4 2 1 1 2 1 1 Lift frame Side mount bolt Locknut Front mounting bolt Front mount block Lifting eye Flat washer Lock washer Lifting-eye bolt 2. 1 Use Qty. Install the lift frame.
PAGE 2
3. Remove the bolts and nuts retaining the handle support braces and remove the braces (Figure 1). Retain the upper nuts for later installation. 4. Install the lift frame to the machine (Figure 2). Note: Tilt the frame toward the rear of the machine; lower it over the engine and then tilt it forward to properly align the frame. Note: Leave the bolts in the handle so that the handle remains in place. g242156 Figure 2 1. Front mount flange 4. Front mount block (inside chassis) 2.
PAGE 3
14. Install the lifting eye, washers, and bolt to the top of the lift frame as shown in Figure 3.
PAGE 4
PRELIMINARY