Installation Instructions

FormNo.3423-691RevA

ProControl

™

DamperKit

2011andAfterTimeCutter

RidingMower

ModelNo.138-7588

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Damper2Installthekit.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Movethemotion-controlleverstotheNEUTRAL-LOCKposition.

3.Engagetheparkingbrake.

4.Shutofftheengineandremovethekey.

g037289

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3423-691*A

PAGE 1
Form No. 3423-691 Rev A Pro Control™ Damper Kit 2011 and After TimeCutter® Riding Mower Model No. 138-7588 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. Damper 2 Install the kit. Preparing the Machine 1. Park the machine on a level surface. 2. Move the motion-control levers to the NEUTRAL-LOCK position. 3. Engage the parking brake. 4.
PAGE 2
Installing the Kit 1. Remove the 3 shoulder screws from each pod and remove the pods from both sides of the machine (Figure 2). 3. Remove the shoulder screw and washer securing the top of the damper (Figure 4). 4. While holding the damper stud in place using a wrench, remove the locknut (1/4 inch) securing the bottom of the damper (Figure 4). Remove the fuel-tank cap before removing the left pod (Figure 2). g254332 Figure 4 1. Shoulder screw 2. Washer 4. Stud 5. Locknut (1/4 inch) 3. Damper 5.
PAGE 3
8. Install each pod using the previously removed 3 shoulder screws from each side (Figure 5). Install the previously removed fuel-tank cap on the left pod (Figure 5). g253591 Figure 5 1. Shoulder screw 3. Fuel-tank cap 2. Pod 9. Repeat this procedure on the right side of the machine.
PAGE 4