Installation Instructions

ManualsBrandsToro ManualsAttachmentsQAS Drag Pivot Kit, Sand Pro/Infield Pro 3040 and 5040 Traction Unit

FormNo.3424-975RevA

ToothRakePivotKit

SandPro

/IneldPro

3040and5040TractionUnit

ModelNo.138-9086

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Removetheexistingbracket.

Drawbar1

Stopplate

Spacer

Bolt(1/2x5-1/2inches)

Locknut(1/2inch)

Clevispin

Washer4

Cotterpin

Installthedrawbartotheattachmentadapter.

Bolt(1/2x1-3/4inches)

Flange-headbolt(3/8x1inch)

Locknut(1/2inch)

Flangenut(1/2inch)

Flangenut(3/8inch)

Installtheraketothedrawbar.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3424-975*A

Summary of content (4 pages)

PAGE 1
Form No. 3424-975 Rev A Tooth Rake Pivot Kit Sand Pro®/Infield Pro® 3040 and 5040 Traction Unit Model No. 138-9086 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Use No parts required – Remove the existing bracket.
PAGE 2
Removing the Existing Bracket 1. Remove and discard the cotter and clevis pins securing the existing bracket and lower end of the latch mechanism (Figure 1). g265963 Figure 3 g019966 Figure 1 2. Remove and discard the fasteners securing the bracket to the attachment (Figure 2). Discard the bracket. 1. Clevis pin 4. Attachment adapter 2. Washer 3. Stop plate 5. Latch mechanism 6. Cotter pin 2.
PAGE 3
6. 7. Important: Ensure that the drawbar is Install a clevis pin through the stop plates, the attachment adapter, and the drawbar (Figure 4). Slide a washer onto the clevis pin and secure it with a cotter pin, bending the ends of the cotter pin to secure it (Figure 4). 90 degrees from the rake. If the drawbar is not set 90 degrees from the rake, the rake will tow at an angle. Installing the Rake to the Drawbar 1.
PAGE 4
Operation 1. Mount the hitch assembly so that the angled side is on top (Figure 9). Adjusting the Rake Angle 2. Assemble the drawbar to the top side of the hanger assembly (Figure 9). You can change the position of the rake to increase or decrease its aggressiveness in the sand. Mount the drawbar and the rake as shown in the following figures to attain the desired aggressiveness.