Installation Instructions

FormNo.3425-282RevC

IdlerKit

BlowerKitforGrandStand

MultiForceMower

ModelNo.139-1546

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Idlerpulley1

Hex-angeheadbolt

Spacer

Mountingbracket1

Carriagebolt

Nut3

Plate1

Installthekit.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.DisengagethePTO,engagetheparkingbrake,

andmovethemotion-controlleversoutwardto

theNEUTRAL-LOCKposition.

3.Shutofftheengineandremovethekey.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3425-282*C

PAGE 1
Form No. 3425-282 Rev C Idler Kit Blower Kit for GrandStand® Multi Force Mower Model No. 139-1546 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. Idler pulley Hex-flange head bolt Spacer Mounting bracket Carriage bolt Nut Plate 1 1 1 1 2 3 1 Install the kit. Preparing the Machine 1. Park the machine on a level surface. 2.
PAGE 2
Installing the Kit 1. Secure the idler pulley to the mounting bracket using the hex-flange head bolt, and spacer (Figure 1). Torque the bolt to 37 to 45 N∙m (27 to 33 ft-lb). g293527 Figure 2 1. Nut (2) 3. Mounting bracket 2. Plate 4. Carriage bolt 4. Route the belt to the idler pulley (Figure 3). Important: Ensure that the wide side of the belt contacts the pulley as shown in Figure 3. Use the shoulder bolt as a guide for the belt. g294691 Figure 1 1. Mounting bracket 4.