Installation Instructions

FormNo.3425-282RevA

IdlerKit

BlowerKitforGrandStand

MultiForceMower

ModelNo.139-1546

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Idlerpulley1

Hex-angeheadbolt(3/8x2-1/2inches)

Spacer

Locknut(3/8inch)

Mountingbracket1

Carriagebolt(5/16x4inches)

Flangenut(5/16inch)

Installthekit.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.DisengagethePTO,engagetheparkingbrake,

andmovethemotion-controlleversoutwardto

theNEUTRAL-LOCKposition.

3.Shutofftheengineandremovethekey.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3425-282*A

PAGE 1
Form No. 3425-282 Rev A Idler Kit Blower Kit for GrandStand® Multi Force Mower Model No. 139-1546 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. Idler pulley Hex-flange head bolt (3/8 x 2-1/2 inches) Spacer Locknut (3/8 inch) Mounting bracket Carriage bolt (5/16 x 4 inches) Flange nut (5/16 inch) 1 1 1 1 1 1 1 Install the kit. Preparing the Machine 1.
PAGE 2
Installing the Kit 1. Secure the idler pulley to the mounting bracket using the hex-flange head bolt (3/8 x 2-1/2 inches), spacer, and locknut (3/8 inch) as shown in Figure 1. g262946 Figure 2 1. Mounting bracket 3. Carriage bolt (5/16 x 4 inches) 2. Flange nut (5/16 inch) 3. Route the belt to the idler pulley (Figure 3). Important: Ensure that the wide side of the belt contacts the pulley as shown in Figure 3. g262947 Figure 1 1. Locknut (3/8 inch) 4. Idler pulley 2. Mounting bracket 5.