Installation Instructions

FormNo.3435-877RevA

Out-FrontBrushKit

forGreensmaster

1018,1021,or1026Mower

ModelNo.139-4371

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Leftbrushbracket

Rightbrushbracket1

Hex-socket-headscrew(5/16x1inch)

Flangelocknut(5/16)

Spacernut

Rubberbumper2

Jamnut2

Leveladjustmentscrew2

Locknut(5/16inch)

Locknut(1/4inch)

Leftbrushrod

Rightbrushrod1

Mountthebrushbrackets.

Brush1

Brushtab2

Lagscrew(5/16x1-1/2inches)

Flange-headbolt(M6x20mm)

Flangelocknut(M6)

Mountthebrush.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3435-877*A

PAGE 1
Form No. 3435-877 Rev A Out-Front Brush Kit for Greensmaster® 1018, 1021, or 1026 Mower Model No. 139-4371 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
Mounting the Brush Brackets 1. If the cutting unit is attached to the traction unit, position the traction unit on a level surface, engage the parking brake, shut off the traction unit, remove the key (if equipped), and disconnect the battery. 2. Remove the 2 hex-socket-head screws securing the basket mounting rods at each side of the cutting unit. 3.
PAGE 3
Mounting the Brush 1. Ensure that the brush is the correct length for your cutting unit; cut the brush at the marked lines as necessary for your cutting unit width. 2. Mount a brush tab to each end of the brush with 2 lag screws (5/16 x 1-1/2 inches). Position the tabs as shown in Figure 4. Note: The brush bristles are cut at an angle. Mount the brush so the longer bristles are closest to the traction unit when mowing. 3.
PAGE 4