Installation Instructions

FormNo.3429-560RevA

StarterFuseKit

GrandStand

Mower

ModelNo.139-5555

InstallationInstructions

Installation

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.DisengagethePTO,movethemotion-control

leverstotheNEUTRAL-LOCKposition,and

engagetheparkingbrake.

3.Shutofftheengine,removethekey,andwait

forallmovingpartstostopbeforeleavingthe

operatingposition.

RemovingtheExistingWire

1.Disconnectthebattery;disconnectthenegative

(-)terminalrstandthepositive(+)terminallast.

2.Removethefueltank;refertotheOperator’s

Manualforthemachine.

3.Insidetheleftsideofthetower,removetherelay

fromtheconnector(Figure1).

g278774

Figure1

1.Relay

2.Connector

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3429-560*A

PAGE 1
Form No. 3429-560 Rev A Starter Fuse Kit GrandStand® Mower Model No. 139-5555 Installation Instructions Installation Removing the Existing Wire Preparing the Machine 1. Disconnect the battery; disconnect the negative (-) terminal first and the positive (+) terminal last. 1. Park the machine on a level surface. 2. 2. Disengage the PTO, move the motion-control levers to the NEUTRAL-LOCK position, and engage the parking brake. Remove the fuel tank; refer to the Operator’s Manual for the machine.
PAGE 2
4. Remove the screw, washer, and nut securing the connector to the tower (Figure 2). 6. Use the terminal removal tool to remove the 2 terminals for the blue wires shown in Figure 4. g278773 Figure 2 1. Nut 2. Washer 5. 3. Screw Use a terminal removal tool to remove the secondary lock from the connector (Figure 3). g278814 Figure 4 1. Blue wires 7. Cut the short wire connected to both terminals as close to the dual terminated terminal as possible (Figure 5). Discard the wire.
PAGE 3
Installing the New Wire 1. 6. Remove the rubber cover from the starter post on the engine and remove the nut (Figure 8). Bend up the tab on the existing terminal to match the terminal of the new wire. g279687 Figure 6 1. Tab on existing terminal 2. Tab on terminal of new wire g278775 2. Figure 8 Install the existing wire harness terminal and the new wire harness terminal into the connector as shown in Figure 5. 1. Rubber cover over starter post 7.
PAGE 4