Installation Instructions

ManualsBrandsToro ManualsRiding ProductsHose Replacement Kit, Reelmaster 3500 Series Traction Unit

FormNo.3431-352RevA

HoseReplacementKit

Reelmaster

3500SeriesTractionUnit

ModelNo.139-5987

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Longhose2

Shorthose

Fitting2

Replacethehoses.

ReplacingtheHoses

g285834

Figure1

1.Shorttting

3.Longhose

2.Shorthose

1.Parkthemachineonalevelsurface,lowerthe

cuttingunits,engagetheparkingbrake,shutoff

theengine,andremovethekey.

2.Drainthehydraulicsystem.

3.Removeanddiscardthehosesandshortttings

showninFigure1.

4.Loosenthettingsonthelefthydrauliccylinder.

5.Installthenewhosesandtallerttings.

Note:Routetheinnerhoses(short)tothelower

teettingandroutetheouterhoses(long)tothe

upperteetting(Figure2).

g285833

Figure2

1.Upperteetting

4.Longhoses

2.Lowerteetting5.Shorthoses

3.Tallttings

6.Positionthettingstotheanglesshownin

Figure3.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3431-352*A

Summary of content (2 pages)

PAGE 1
Form No. 3431-352 Rev A Hose Replacement Kit Reelmaster® 3500 Series Traction Unit Model No. 139-5987 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Long hose Short hose Fitting 2 2 2 Replacing the Hoses Replace the hoses. 3. Remove and discard the hoses and short fittings shown in Figure 1. 4. Loosen the fittings on the left hydraulic cylinder. 5. Install the new hoses and taller fittings.
PAGE 2
g285759 Figure 3 1. 15° 7. 2. 5° 3. 20° Tighten the fittings. Important: Use a backup wrench on all fittings. 8. Fill the hydraulic system with the appropriate hydraulic fluid; refer to the Operator’s Manual. 9. Adjust the 90° fittings on the front cutting units so that they are angled 8° to 10° inward, toward the traction unit. 10. Raise and lower the cutting units completely and ensure that the hoses do not rub against each other.