Installation Instructions

ManualsBrandsToro ManualsAttachmentsDrag Mat Kit, Sand Pro Traction Unit

FormNo.3440-384RevA

DragMatKit

SandPro

TractionUnit

ModelNo.140-0274

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Weightkit100-6442

Not

included

Frontliftframekit08712

Not

included

Installtheweightstothemachine(Models08703,08705,

08743,or08745)orthefrontliftframe(Models08705or

08745only).

Dragmat1

Chain

Screw(5/16x1-1/2inches)

Locknut(5/16inch)

Installthechaintothedragmat.

Leftcradle

Rightcradle1

Bolt(3/8x1-3/8inches)

Flangenut(3/8inch)

Washer(3/8inch)

Shackle

Clevispin

Hairpincotter1

Installthecradles.

Important:FortractionunitModels08703or08743,youmustinstallweightkit100-6442before

operatingthisattachment.

Important:FortractionunitModels08705or08745,youmustinstalleitherweightkit100-6442orfront

liftframekit08712beforeyouoperatethisattachment.

Important:Youmustinstallanishgraderontherearofthemachinebeforethedragmatcan

beinstalled.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3440-384*A

Summary of content (4 pages)

PAGE 1
Form No. 3440-384 Rev A Drag Mat Kit Sand Pro® Traction Unit Model No. 140-0274 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Weight kit 100-6442 Front lift frame kit 08712 Drag mat Chain Screw (5/16 x 1-1/2 inches) Locknut (5/16 inch) Left cradle Right cradle Bolt (3/8 x 1-3/8 inches) Flange nut (3/8 inch) Washer (3/8 inch) Shackle Clevis pin Hairpin cotter Use Qty.
PAGE 2
Installing the Weights or Front Lift Frame Installing the Chain to the Drag Mat Note: Ensure that your machine has the appropriate number of weights. If necessary, install additional weights from weight kit 100-6442 (sold separately). Secure 1 end of the chain to the drag mat with a screw (5/16 x 1-1/2 inches) and a locknut (5/16 inch); refer to Figure 2. 1. Park the machine on a level surface, engage the parking brake, remove the key (if equipped), and wait for all moving parts to stop. 2.
PAGE 3
Installing the Cradles 1. Operation Install the cradles to the finish grader; refer to Figure 3. Stowing the Drag Mat Whenever you are not using the drag mat, stow it in the cradles. To stow the drag mat, simply roll it up and place it in the cradles. Using the Drag Mat Important: Do not drive the machine backward when the drag mat is connected and on the ground; the drag mat gets caught under the wheels, and damages the machine. g024786 Figure 3 1. Finish grader 6. Chain 2.
PAGE 4