Installation Instructions

FormNo.3436-773RevA

HeavyDutySpringKit

TimeCutter

MyRideRidingMower

ModelNo.140-2051

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Nopartsrequired

–

Removetheexistingfrontspring.

Spring

1Installthenewheavy-dutyspring.

Springspacer

Setscrew

Spring-lifttube

Installthespringspacers.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Disengagetheblade-controlswitch.

3.Movethemotion-controlleversoutwardtothe

NEUTRAL-LOCKposition.

4.Shutofftheengineandremovethekey.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3436-773*A

PAGE 1
Form No. 3436-773 Rev A Heavy Duty Spring Kit TimeCutter® MyRide Riding Mower Model No. 140-2051 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. No parts required – Remove the existing front spring. Spring 1 Install the new heavy-duty spring. Spring spacer Set screw Spring-lift tube 2 2 1 Install the spring spacers. Preparing the Machine 1.
PAGE 2
Removing the Existing Front Spring Installing the New Heavy-Duty Spring 1. Place a 38 x 89 mm (2 x 4 inch) board under the foot rest to block the front of the platform. 2. Remove the 2 shoulder bolts and 2 locknuts (3/8 inch) securing the existing front spring (Figure 1). Install the new spring using the previously removed 2 shoulder bolts and 2 locknuts (3/8 inch) as shown in Figure 1. Retain the 2 shoulder bolts and 2 locknuts (3/8 inch). 3. Remove the existing front spring (Figure 1).
PAGE 3
Installing the Spring Spacers 5. 1. Raise the seat. 2. Place the spring-lift tube onto the end of the torsion spring (Figure 2). Secure the spring spacer to the swing-arm post using the set screw (Figure 4). Note: Ensure that the spring-lift tube is securely seated on the end of the torsion spring. g309475 Figure 2 1. Spring-lift tube g309473 Figure 4 2. Torsion spring 1. Swing-arm post 3. Set screw 2. Spring spacer 3. Slide the spring spacer onto the swing-arm post (Figure 3). 4.
PAGE 4