Installation Instructions

ManualsBrandsToro ManualsBlowers/VacuumsChute Position Indicator Kit, Pro Force Debris Blower

FormNo.3436-812RevA

ChutePositionIndicatorKit

ProForce

DebrisBlower

ModelNo.140-2257

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Rotationgauge1

Greenindicatortab

Redindicatortab1

Hex-socketheadbolt(1/4x5/8inch)

Locknut(1/4inch)

Chutepositiondecal

Installthekit.

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurfaceandengage

thetowvehicleparkingbrake.

2.Shutofftheengine,removethekey,disconnect

thespark-plugwire,andwaitforallmovingparts

tostop.

3.Chockthewheels.

4.Removethemachinefromthetractionunit.

CAUTION

Ifyouleavethekeyintheignition

switch,someonecouldaccidentlystart

theengineandseriouslyinjureyouor

bystanders.

Removethekeyfromtheswitchbefore

youdoanymaintenance.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3436-812*A

Summary of content (4 pages)

PAGE 1
Form No. 3436-812 Rev A Chute Position Indicator Kit Pro Force® Debris Blower Model No. 140-2257 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine. 2 Rotation gauge Green indicator tab Red indicator tab Hex-socket head bolt (1/4 x 5/8 inch) Locknut (1/4 inch) Chute position decal 1 1 1 4 4 1 Install the kit.
PAGE 2
Installing the Kit Parts needed for this procedure: 1 Rotation gauge 1 Green indicator tab 1 Red indicator tab 4 Hex-socket head bolt (1/4 x 5/8 inch) 4 Locknut (1/4 inch) 1 Chute position decal g311475 Figure 2 1. Position the indicator 30 mm (1-3/16 inches) from the edge of the nozzle. 3. Procedure 1. Install the rotation gauge to the nozzle guide using the existing hardware as shown in Figure 1. 2. Drill 2 holes (6.5 mm or 1/4 inch) here. If not present, drill 2 holes (6.
PAGE 3
4. Install the red indicator tab to the top of the nozzle and install the green indicator tab to the left side of the nozzle using the provided hardware as shown in Figure 4. g311489 Figure 4 1. Red indicator tab 3. Locknut (1/4 inch) 2. Hex-socket head bolt (1/4 x 5/8 inch) 4. Green indicator tab 5. Install the chute position decal facing the operator, centered over the slot in the rotation gauge (Figure 5). g311490 Figure 5 1. Install the chute position decal here.
PAGE 4