Installation Instructions

FormNo.3436-435RevA

RubberDeectorKit

ProlineCommercialWalk-BehindMower

ModelNo.140-4300

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachineforinstallation.

Rubberdeector

Installtherubberdeector.

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Shutofftheengineandremovethekey.

InstallingtheRubber

Deector

Partsneededforthisprocedure:

Rubberdeector

RemovingtheDeector

1.Removethecotterpin(Figure1).

Retainthepinforusein2InstallingtheRubber

Deector(page1).

2.Disengagethespringfromthenotchinthe

deectorbracketandslidetherodoutofthe

weldeddeckbrackets,spring,anddischarge

deector(Figure1).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3436-435*A

PAGE 1
Form No. 3436-435 Rev A Rubber Deflector Kit Proline Commercial Walk-Behind Mower Model No. 140-4300 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 Description Use Qty. No parts required – Prepare the machine for installation. Rubber deflector 1 Install the rubber deflector. 1 2 Preparing the Machine No Parts Required Installing the Rubber Deflector Parts needed for this procedure: Procedure 1 1.
PAGE 2
g190642 Figure 1 g006049 1. Rod 4. Spring 2. Cotter pin 5. Deck brackets 3. Deflector 6. Spring installed over the rod 3. Figure 2 1. Rod and spring assembly installed 2. Loop end of the spring installed into the notch in the deflector bracket Remove the discharge deflector. 5. WARNING An uncovered discharge opening could allow the machine to throw objects at you or bystanders and result in serious injury. Also, contact with the blade could occur. 6.