Installation Instructions

FormNo.3437-992RevA

SnowTireKit

GrandStand

Mower

ModelNo.140-4310

InstallationInstructions

Installation

PreparingtheMachine

1.Parkthemachineonalevelsurface,disengagethePTO,andengagetheparkingbrake.

2.Shutofftheengine,removethekey,andwaitforallmovingpartstostopbeforeleavingtheoperating

position.

3.Raisetherearofthemachinesothatthewheelsareofftheground.Supportthemachineusingjack

stands.

Note:Usejackstandsratedforyourmachine.RefertotheOperator’sManualforyourmachineto

determinetheweight.

WARNING

Mechanicalorhydraulicjacksmayfailtosupportthemachineandcauseseriousinjury.

Usejackstandswhensupportingthemachine.

InstallingtheTires

1.Removethe2existingtires.

2.Installthe2snowtiresusingtheexistinglugnutsthatyouremoved.

3.Torquethelugnutsto115to142N∙m(85to105ft-lb).

4.Ensurethatairpressureinthetiresis83to97kPa(12to14psi).

Note:Dependingonconditions,loweringtirepressurecanincreasetraction.

g314322

Figure1

1.Snowtire2.Lugnut(4)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3437-992*A

PAGE 1
Form No. 3437-992 Rev A Snow Tire Kit GrandStand® Mower Model No. 140-4310 Installation Instructions Installation Preparing the Machine 1. Park the machine on a level surface, disengage the PTO, and engage the parking brake. 2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving the operating position. 3. Raise the rear of the machine so that the wheels are off the ground. Support the machine using jack stands. Note: Use jack stands rated for your machine.
PAGE 2