Installation Instructions

FormNo.3436-239RevA

AluminumSpindleBlowerAdapterKit

Grandstand

orZMaster

Mower

ModelNo.140-4961

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Pulleyassembly1

Pulley-platemount1

Flangenut(3/8inch)

Installthepulleyassemblyandbelt.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

PreparingtheMachine

Performthefollowingproceduretopreparethemachineforattachingtheblowerandnishingkit.

1.DisengagethePTO,movethemotion-controlleverstotheNEUTRAL-LOCKposition,andsettheparking

brake.

2.Shutofftheengine,removethekey,andwaitforallmovingpartstostopbeforeleavingtheoperating

position.

3.Repairallbentordamagedareasofmowerdeckandreplaceanymissingparts.

4.Cleanthemachineofanydebrisonthedeckorrearpartofthemachinetoeaseinstallation.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3436-239*A

PAGE 1
Form No. 3436-239 Rev A Aluminum Spindle Blower Adapter Kit Grandstand® or Z Master® Mower Model No. 140-4961 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. Pulley assembly Pulley-plate mount Flange nut (3/8 inch) 1 1 3 Install the pulley assembly and belt. Note: Determine the left and right sides of the machine from the normal operating position.
PAGE 2
Installing the Pulley Assembly and Belt 1. 2. Insert the pulley-plate mount studs into the holes in the sheave (Figure 2). Remove the top nut, washer, and sheave from the spindle (Figure 1). Note: Note the orientation of the sheave when you remove it from the spindle to ensure that you install it properly later in the process. g302390 Figure 2 1. Sheave 3. 2. Pulley-plate mount studs Loosely install the 3 nuts to the studs (Figure 3).
PAGE 3
4. 6. Install the sheave assembly to the spindle using the washer and top nut (Figure 4). Align the new pulley assembly so that the openings fit over the nuts (Figure 5). g302411 Figure 5 1. Pulley assembly 7. g302413 3. Sheave assembly 2. Washer 4. Spindle 5. Turn the pulley to lock it into position (Figure 6). Note: If the pulley does not turn, loosen the Figure 4 1. Top nut 2. Nuts nuts more to raise the nuts and allow the pulley to lock into position.
PAGE 4