Installation Instructions

FormNo.3450-599RevA

HandlePivotRepairKit

Greensmaster

1018,1021,1026,ore1021Greensmower

ModelNo.140-9399

InstallationInstructions

Installation

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Shutofftheengine.

RemovingtheExisting

FrameHardware

1.Removethenut,washers,andboltthatsecures

thehandleassemblytotheframeassembly.

Retainthewashers.

2.Supportthehandleassemblywhileitisremoved

fromtheframeassembly.Haveanassistant

holdthehandleassembly,orpositionthehandle

assemblyagainstawall.

g375122

Figure1

1.Handleassembly4.Nut

2.Bolt5.Frameassembly

3.Washers

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3450-599*

PAGE 1
Form No. 3450-599 Rev A Handle Pivot Repair Kit Greensmaster® 1018, 1021, 1026, or e1021 Greensmower Model No. 140-9399 Installation Instructions Installation Preparing the Machine 1. Park the machine on a level surface. 2. Engage the parking brake. 3. Shut off the engine. Removing the Existing Frame Hardware 1. Remove the nut, washers, and bolt that secures the handle assembly to the frame assembly. Retain the washers. 2. Support the handle assembly while it is removed from the frame assembly.
PAGE 2
Installing the New Frame Hardware 1. Remove the rough area of the frame casting. • A of Figure 2 shows the rough area of the frame casting. • B of Figure 2 shows the flat, sanded area of the frame casting.
PAGE 3
2. Have an assistant position the handle assembly on the frame and hold it in a forward position (Figure 3) g380288 Figure 3 3. Use the pivot fastener (1/2 x 6-1/2 inches), existing washers, and new locknut to secure the handle assembly to the frame assembly (Figure 4). Note: You can use a mallet to install the pivot fastener, which has a raised knurled surface. g375131 Figure 4 1. Handle assembly 4. Locknut 2. Pivot fastener (1/2 x 6-1/2 inches) 5. Frame assembly 3. Washers 4.
PAGE 4