Installation Instructions

ManualsBrandsToro ManualsRiding ProductsSeat Replacement Kit, Sand Pro 3040 or 5040 Traction Unit

FormNo.3442-108RevA

SeatReplacementKit

SandPro

3040or5040TractionUnit

ModelNo.144-1380

InstallationInstructions

Installation

OrderingtheServiceDecal

Partsneededforthisprocedure:

ServiceDecal(refertothePartsCatalogforyour

machine)

Procedure

Orderandreceiveanewservicedecalforyour

machinefromanauthorizedTorodistributorbefore

installingtheseatreplacementkit;refertotheParts

Catalogforyourmachine.

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurfaceandlower

allattachments.

2.Engagetheparkingbrake.

3.Shutofftheengineandremovethekey.

4.Waitforallmovingpartstostopbeforeleaving

theoperator’sseat.

RemovingtheSeat

NoPartsRequired

Procedure

1.Rotatetheoperator’sseatup(Figure1).

g334917

Figure1

2.Removethecabletiethatsecuresthewire

harnesstotheseatbase(Figure2).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3442-108*

Summary of content (4 pages)

PAGE 1
Form No. 3442-108 Rev A Seat Replacement Kit Sand Pro® 3040 or 5040 Traction Unit Model No. 144-1380 Installation Instructions 3 Installation 1 Removing the Seat Ordering the Service Decal Parts needed for this procedure: 1 Service Decal (refer to the Parts Catalog for your machine) No Parts Required Procedure 1. Rotate the operator’s seat up (Figure 1).
PAGE 2
g334910 Figure 2 1. Operator’s presence switch 2. 2-socket connector 3. 4. 3. Cable tie Disconnect the 2-socket connector of the harness from the operator’s presence switch at the bottom of the seat (Figure 2). g334912 Figure 4 Remove the 2 pins that secure the seat pivot brackets to the machine (Figure 3). 4 Note: Retain the pins for assembly in 4 Installing the Seat (page 2). Installing the Seat Parts needed for this procedure: 1 Seat and base 1 Cable tie Procedure g334911 1. Figure 3 1.
PAGE 3
g334909 Figure 7 1. Operator’s presence switch 2. 2-socket connector 5. 3. Cable tie 4. Seat base Thread the cable tie through the 2 holes in the seat base as shown in Figure 7, and secure the wire harness to the base. g334907 5 Figure 5 2. Align the holes in the seat pivot bracket with the pivot bracket on the front brace of the frame (Figure 6). Installing the Service Decal Parts needed for this procedure: Procedure 1.
PAGE 4
g336379 Figure 10 1. Hydraulic-control switch (machines with the optional rear remote hydraulic kit) 2. Traction pedal g334916 Figure 9 4. 6 Testing the Operator’s Presence Switch No Parts Required Procedure 1. Sit in the operator's seat, ensure the traction pedals are in the NEUTRAL position, and the parking brake is engaged. 2. Start the engine. 3. Rise off the seat and perform 1 of the following: 5. • Actuate the traction pedal (Figure 9).