Service Manual

GLOSSARY
3-4
Demystifi ction
Glossary
GLOSSARY
Clutch Burnishing Procedure
The clutch should be burnished as part of the pre
delivery service, or whenever a new clutch is installed.
Burnishing polishes the clutch plate, allowing for
smooth clutch engagement.
With a PTO driven attachment installed (i.e., mower,
snowthrower, or tiller), run the engine at half throttle.
Engage and disengage the clutch 5 times (10 seconds
on/10 off).
Fuse
Location
The 20 amp fuse is located at the right side of the fuel
tank. It is wired in series between the battery positive
terminal and the “B” terminal of the ignition switch
(Figure 3).
Purpose
Fuses are electrical safety valves that protect wiring
and electrical components from damage from high
current fl ow by creating an open circuit.
Fuses are rated for a specifi c current fl ow (amps).
Never connect a jumper wire across a fuse. Never
connect additional fuses in parallel.
Always use the proper fuse. Always fi nd and correct
the reason for a blown fuse.
Figure 2
3-7
Figure 3
fuseIII