Service Manual

GLOSSARY
D
emy
stifi ction Glossary
3-7
GLOSSARY
Testing the RMC system – Manual PTO - keyswitch
in “Reverse Caution” Unactivated (Indicator light
off)
1. Start the engine; place the keyswitch in the reverse
caution position.
2. With the seat occupied, place the PTO lever in the
“on” position.
3. With the brake applied, move the shift lever to the
reverse position.
4. The engine should shut down.
Testing the RMC system – Manual PTO - keyswitch
in “Reverse Caution” Activated (Indicator light on)
1. Start the engine; place the keyswitch in the reverse
caution position.
2. Press the reverse push button.
3. With the seat occupied, place the PTO lever in the
“on” position.
4. With the brake applied, move the shift lever to the
reverse position.
5. The engine should continue to run.
Testing the RMC system – Electric PTO - keyswitch
in “Normal”
1. Start the engine; place the keyswitch in the normal
position.
2. With the seat occupied, pull the PTO switch to the
“on” position.
3. With the brake applied, move the shift lever to the
reverse position.
4. The electric clutch should disengage.
5. Place the shift lever in forward.
6. The electric clutch should remain disengaged.
7. Cycle the PTO switch off and on.
8. The electric clutch should re-engage.
Testing the RMC system – Electric PTO - keyswitch
in “Reverse Caution” Unactivated (Indicator light
off)
1. Start the engine; place the keyswitch in the reverse
caution position.
2. With the seat occupied, pull the PTO switch to the
“on” position.
3. With the brake applied, move the shift lever to the
reverse position.
4. The electric clutch should disengage.
5. Place the shift lever in forward.
6. The electric clutch should remain disengaged.
7. Cycle the PTO switch off and on.
8. The electric clutch should re-engage.
Testing the RMC system – Electric PTO - keyswitch
in “Reverse Caution” Activated (Indicator light on)
1. Start the engine; place the keyswitch in the reverse
caution position.
2. Press the reverse push button.
3. With the seat occupied, pull the PTO switch to the
“on” position.
4. With the brake applied, move the shift lever to the
reverse position.
5. The electric clutch should remain engaged.