Service Manual

8-19

WPM Drive Systems Manual

BBC/BOS/BCS

BBCCableRemoval(ToroVacuPower/

Lawn-BoyMedallion)

1. Remove the two anged head self-tapping screws

securing the screen panel to the housing and

remove the screen panel as shown in Figure 211.

3. Bend the throttle control locking tab back slightly and

tap the throttle control from the control panel with a

rubber mallet. Place a piece of duct tape over the

heads of the handle and the BBC control box. This

will prevent the control box components from falling

out of the handle during disassembly.

4. Remove the three anged head screws securing the

control box halves.

5. Remove the two nylon locknuts securing the control

box to the handle and carefully remove the right

control housing half.

6. Slip the end of the BBC cable from the cable lever

and remove the cable (Fig. 212).

2. On early models, the end of the BBC cable sheath

has two protruding ears that catch the underside of

the cable bracket. Remove the cable by squeezing

the ears together, then pulling the cable out

vertically. Later models use a clip that must be

pushed to the side to remove.

Fig211 3428-0079

Fig212 g 36

A. Screws B. Screen Panel

A. BBC cable lever B. BBC cable