Service Manual
9-5
WPM Drive Systems Manual
HANDLES&CONTROLCABLES
7. Slide the handle up and off (Fig. 265).
Reassembly
Reassemble in reverse order.
1. There are 3 bosses on the inside of the guide. The
top and bottom ones receive the mounting screws.
The boss in the photo must line up with the end of
the control rod. This boss keeps the rod from moving
sideways and falling out of the handle (Fig. 267).
Fig265 DSC-4819a
8. If you need to replace the traction control rod or
either of the springs, one of the handle guides will
need to be removed. The guides are held on by 2
screws (Fig. 266).
Fig266 DSC-4821a
Fig267 DSC-4828a
2. One end of the springs goes into a hole in the
handle, the other around the traction control rod. The
springs apply pressure to the handle to hold it in the
retracted, upper position (Fig. 268).
Fig268 DSC-4814a