MSDS

clothing before reuse. Clean or
discard contaminated leather goods.
If material is injected under the skin,
seek medical attention immediately.
Ingestion: Do not induce vomiting
unless directed to by a physician. Do
not give anything to drink unless
directed to by a physician. Never
give anything by mouth to a person
who is not fully conscious. Seek
medical attention immediately.
Notes to Physician: INGESTION:
The viscosity range of the product(s)
represented by this MSDS is greater
than 100 SUS at 100°F. There is a
low risk of aspiration upon ingestion
Careful gastric lavage or emesis
may be considered to evacuate
large quantities of material.
such as heavy nitrile rubber if frequent or prolonged
contact is expected. Use heat-protective gloves when
handling product at elevated temperatures.
Body Protection: Avoid prolonged or repeated skin
contact. Use clean protective clothing if splashing or
spraying conditions are present such as long-sleeved
garment. Remove oil contaminated clothing and launder
before reuse. Heavily contaminated clothing and leather
goods should be removed promptly and cleaned or
discarded.
Respiratory Protection: The need for respiratory
protection is not anticipated under normal use conditions
and with
adequate ventilation. If elevated airborne concentrations
above applicable work place exposure levels are
anticipated, a NIOSH-approved organic vapor respirator
equipped with a dust/mist prefilter should be used.
Protection factors vary depending upon the type of
respirator used. Respirators should be used in accordance
with OSHA requirements (29CFR 1910.134).
General Comments: Use good personal hygiene
practices. Wash hands and other exposed skin areas with
plenty of mild soap and water before eating, drinking,
smoking, use of toilet facilities, or leaving work. DO NOT
use gasoline, kerosene, solvents or harsh abrasives as
skin cleaners. Since specific exposure standards/control
limits have not been established for this product, the "Oil
Mist, Mineral" exposure limits shown below are suggested
as minimum
control guidelines.
Fire and Explosion Hazards
Extinguishing Media Special Fire Fighting Procedures Unusual Fire and Explosion Hazards
Use dry chemical, foam,
carbon dioxide or water fog.
Water or foam may cause
frothing.
Carbon dioxide and inert gas
can displace oxygen. Use
caution when applying carbon
dioxide or inert gas in confined
spaces.
NFPA Flammability Classification:
NFPA Class-IIIB combustible material.
Flash Point: Open cup 254°C (489°F)
(Cleveland.).
Special Properties: This
material can burn but will not readily
ignite. This material will release vapors
when heated above the flash point
temperature that can ignite when exposed
to a source of ignition. In enclosed
spaces, heated vapor can ignite with
explosive force. Mists or sprays may burn
at temperatures below the flash point.
Protection of Fire Fighters: Firefighters
must use full bunker gear including
NIOSH-approved positive pressure
self-contained breathing apparatus to
protect against potential hazardous
combustion or decomposition products
and oxygen deficiencies
Hazardous Combustion Products:
Carbon dioxide, carbon monoxide,
smoke, fumes, unburned hydrocarbons
and oxides of sulfur, phosphorus, zinc
and/or nitrogen.
Conditions to Avoid: Keep away from
extreme heat, sparks, open flame, and
strongly oxidizing conditions.
Materials Incompatibility: Strong
oxidizers.
RELEASED Version ©Toro 2009-2009