Form No. 3418-438 Rev D Flex Force Power System™ 60V MAX 22in Recycler® Lawn Mower Model No. 20361—Serial No. 400000000 and Up Model No. 20361T—Serial No. 400000000 and Up Register at www.Toro.com.
Introduction For assistance, please see www.Toro.com/support for instructional videos or contact 1-888-384-9939 before returning this product. This rotary-blade, walk-behind lawn mower is intended to be used by residential homeowners. It is designed primarily for cutting grass on well-maintained lawns on residential properties. It is designed to use lithium-ion battery pack Model 88660 (provided with Model 20361) or Model 88675; it can also use battery pack Model 88625 or Model 88640.
Contents Safety Safety ....................................................................... 3 Safety and Instructional Decals .......................... 5 Setup ........................................................................ 8 1 Mounting the Battery Charger (Optional) ........................................................ 8 2 Unfolding the Handle ....................................... 9 3 Assembling the Grass Bag............................... 9 Product Overview ............................
before adjusting, servicing, cleaning, or storing the machine. use an attachment plug adapter of the proper configuration for the power outlet if needed. 7. Do not use a damaged or modified battery pack or battery charger, which may exhibit unpredictable behavior that results in fire, explosion, or risk of injury. 8. If the supply cord to the battery charger is damaged, contact an Authorized Service Dealer to replace it. 9. Do not use non-rechargeable batteries. 10. 11. 12. 13. 14.
2. 3. 4. 5. 6. 7. 8. 9. 10. whether the machine will operate properly. Check for misaligned and binding moving parts, broken parts, mounting, and any other condition that may affect its operation. Unless indicated in the instructions, have an Authorized Service Dealer repair or replace a damaged guard or part. before adjusting, servicing, cleaning, or storing the machine. Do not attempt to repair the machine except as indicated in the instructions.
decal140-1328 140-1328 1. Warning—read the Operator’s Manual. 4. Thrown object hazard—keep bystanders away; shut off the engine and wait for all moving parts to stop before leaving the machine; pick up debris before mowing. 2. Cutting/dismemberment 5. Cutting/dismemberment hazard of the hand, mower hazard of the foot, mower blade—stay away from blade—do not mow up moving parts; keep all or down slopes; only guards and shields in mow across slopes; look place. behind you when mowing in reverse. 3.
decal137-9462 137-9462 decal137-9463 137-9463 1. The battery pack is charging. 2. The battery pack is fully charged. 3. The battery pack is over or under the appropriate temperature range. 4.
Setup Important: To prevent accidental starting, do not insert the electric-start button into the electric-start ignition (if equipped) until you are ready to start the motor. Note: The battery pack is not fully charged when it is purchased. Before using the machine for the first time, refer to Charging the Battery Pack (page 15).
2 Unfolding the Handle No Parts Required Procedure WARNING Unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cable(s) when folding or unfolding the handle. • Ensure that the cable(s) are routed to the outside of the handle. • If a cable is damaged, contact an Authorized Service Dealer. Important: Hold the handle while engaging the handle locks to avoid pinching your hands.
Product Overview g274502 Figure 7 1. Battery charger (included with Model 20361) 2. Battery pack (included with Model 20361) Specifications Appropriate Temperature Ranges Figure 5 6. Washout port (not shown) 2. Blade-control bar 7. Battery compartment 3. Electric-start button 8. Cutting-height lever (4) 4. Electric-start ignition 9.
Operation Note: Determine the left and right sides of the machine from the normal operating position. Before Operation Installing the Battery Pack Important: Operate the battery pack only in temperatures that are within the appropriate range; refer to Specifications (page 10). 1. Make sure that the vents on the battery are clear of any dust and debris. 2. Lift up the battery-compartment lid (A of Figure 8). 3.
Adjusting the Handle Height You may raise or lower the handle to a position comfortable for you. Rotate the handle lock, move the handle to 1 of 2 positions, and lock the handle into position (Figure 9). g274514 Figure 9 Adjusting the Cutting Height Adjust the cutting height as desired. Set all wheels to the same cutting height (Figure 10).
During Operation Starting the Machine 1. Ensure that the battery pack is installed in the machine; refer to Installing the Battery Pack (page 11). 2. Insert the electric-start button into the electric starter (A of Figure 11). 3. Press the electric-start button and keep it pressed (B of Figure 11). 4. Squeeze the blade-control bar and hold it to the handle until the motor starts (C of Figure 11).
Bagging the Clippings Use the grass bag when you want to collect grass and leaf clippings from the lawn. If the side-discharge chute is on the machine, remove it; refer to Removing the Side-Discharge Chute (page 14). Installing the Grass Bag 1. Raise and hold up the rear deflector (A of Figure 13). 2. Install the grass bag, ensuring that the pins on the bag rest in the notches on the handle (B of Figure 13). 3. Lower the rear deflector.
Removing the Battery Pack from the Machine 1. Lift up the battery-compartment lid. 2. Press the battery-pack latch to release the battery pack and remove the battery pack. 3. Close the battery-compartment lid. • If there are more than 13 cm (5 inches) of leaves on the lawn, mow at a higher cutting height and then again at the desired cutting height. • Slow down your mowing speed if the machine does not cut the leaves finely enough.
4. Wash out the area under the rear door where the clippings go from the underside of the machine to the grass bag. Note: Wash out the area with the bag-on-demand (if equipped) in both the fully forward and fully rearward positions. 5. Attach a garden hose that is connected to a water supply to the washout port (Figure 17). g268087 Figure 16 g251300 1. LED indicator light Figure 17 2. Charger venting areas 1. Washout port 5. 6.
Folding the Handle WARNING Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or unfolding the handle. • If a cable is damaged, contact an Authorized Service Dealer. 1. Remove the electric-start button (Figure 18). g251299 Figure 19 g251288 Figure 18 5. 2. Hold the handle while disengaging the handle locks to avoid pinching your hands. 3.
Storing the Machine in the Vertical-Stow Position During the mowing season or in the off-season, you can store your machine in the vertical position to minimize storage space. WARNING Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or unfolding the handle. • If a cable is damaged, contact an Authorized Service Dealer. 1. Remove the electric-start button and battery from the machine. 2.
Maintenance Remove the electric-start button and battery pack from the machine before maintaining or cleaning the machine. Use only the manufacturer’s recommended replacement parts and accessories. Inspect and maintain the machine regularly. Have the machine repaired only by an Authorized Service Dealer. Lubricating the Machine g231389 You do not need to lubricate the machine; all the bearings have been lubricated at the factory for the life of the machine. Figure 22 4.
Storage Important: Store the machine, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page 10). Important: If you are storing the battery pack for the off-season, charge it until 2 or 3 LED indicators turn green on the battery. Do not store a fully charged or fully depleted battery.
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem The machine does not start. Possible Cause Corrective Action 1. The battery is not fully installed in the machine. 1. Remove and then replace the battery into the machine, making sure that it is fully installed and latched. 2.
Problem The machine is producing a beeping sound. Possible Cause Corrective Action 1. The battery pack is not charged. 1. Remove the battery pack from the machine and charge it. 2. The machine is in an unsafe position for operation. 3. The machine is overloaded. 2. Ensure that the machine is not at an extreme angle while operating. 3. Cut the grass at a higher height of cut or walk at a slower pace while mowing. 4.
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
