Setup Instructions

Printed in USA

The Toro Company – 1996

FORM NO. 3319–314GB

Models 21040, 21042 & 21043

Rain Shield

Reinstallation

 

The clear plastic Rain Shield can become detached

from the mower due to rough handling during

shipping. If the Rain Shield is not attached to the

mower when the carton is opened, reinstall the Rain

Shield onto the shroud as follows:

1. Reinstall the mounting tabs onto the Rain Shield

mounting pins (Fig. 1).

2. Rotate the straight end of the spring and hold it

up in the vertical position (Fig. 1).

Figure 1

1. Mounting Tab

2. Straight End of Spring

3. Rain Shield

3. Snap the mounting tabs into the matching holes

in the shroud (Fig. 2).

Figure 2

1. Mounting Tab 2. Shroud