Addendum

ManualsBrandsToro ManualsLawn MowersToro 22164

FormNo.3360-643RevA

CommercialTrimMowers

VariousModels

Addendum

Important:Theinstructionsinthis

Addendum

replaceprocedure1inSetupinyour

Operator’ s Man ual

;

therefore,usetheseinstructionswhenyousetupyourmower.

Note:InyourPartsCatalog,replacethe2hex-headscrews(322-7)inthehandleassemblywiththe2handlescrews

(92-4095).Also,replacethe2self-tappinghexheadscrews(701243)withthe2self-tappinghexheadscrews

(32144-49).Thespacer(5-0652)isnotlistedinyourPartsCatalog.Therefore,keepthisAddendumwithyourParts

Catalog.

InstallingtheHandle

Partsneededforthisprocedure:

Oval-headbolt(models22164,22164TE,and22194

only)

Locknut(models22164,22164TE,and22194only)

Upperhandle(models22164,22164TE,and22194

only)

Oval-headbolt(models22163and22193only)

Locknut(models22163and22193only)

Self-tappinghexheadscrew(32144-49;allmodels)

Washer(allmodels)

Spacer(5-0652;allmodels)

Cabletie(allmodels)

Procedure

1.Attachtheupperhandletothelowerhandleusing

4oval-headboltsand4locknuts(Models22164,

22164TE,and22194only).

Note:Ensurethattheboltheadsaretotheoutside

ofthehandle.

2.Attachthehandletothemowerhousingwith

2self-tappinghexheadscrews,2washers,and

2spacers(Figure1),butdonottightenthe

self-tappinghexheadscrews.

Note:Ensurethatyouinsertthespacersbetween

themowerhousingandthehandle(Figure2).

Figure1

1.Endcaponreardoorrod

4.Handlebrace(2)

2.Self-tappinghexhead

screw,washer,andspacer

(2)

5.Boltheadalignedwiththe

handle

3.Locknut(2)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3360-643 Rev A Commercial Trim Mowers Various Models Addendum Important: The instructions in this Addendum replace procedure 1 in Setup in your Operator’s Manual; therefore, use these instructions when you set up your mower. Note: In your Parts Catalog, replace the 2 hex-head screws (322-7) in the handle assembly with the 2 handle screws (92-4095). Also, replace the 2 self-tapping hex head screws (701243) with the 2 self-tapping hex head screws (32144-49).
PAGE 2
so that the bolt heads are tight against the handle, and then tighten the locknuts (Figure 1). 6. Tighten the rest of the fasteners on the handle and handle braces. 7. Use the cable tie provided to secure the control cable(s) to the handle. Note: Attach the cable tie as low as possible on the handle to prevent the cable(s) from hooking onto the end cap on the rear door rod and interfering with the self-propel system (Figure 1). 12345 G008823 Figure 2 1. Mower housing 2. Spacer 4. Washer 5.