Operator's Manual

Operation
18
Driving Forward or Backward
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle control in the “FAST” position for best
performance.
Note: Throttle position can be utilized to
operate at slower speeds.
Forward
To go forward, slowly push the traction control levers
forward (Fig. 8).
To go straight, apply equal force to both traction
control levers (Fig. 8).
To turn, decrease force on the traction control lever
toward the direction you want to turn (Fig. 8).
The farther you move the traction control levers in
either direction, the faster the machine will move in
that direction.
To slow or stop, move the traction control levers to
neutral.
Backward
To go backward, slowly pull the traction control
levers rearward (Fig. 8).
To go straight, apply equal force to both traction
control levers (Fig. 8).
To turn, decrease force on the traction control lever
toward the direction you want to turn (Fig. 8).
To slow or stop, move the traction control levers to
neutral.
Stopping the Machine
To stop the machine, move the traction control levers
to neutral, lower loader arms to the ground, and turn
the ignition key to “OFF” to stop the engine.
Remember to remove the key from the key switch.
POTENTIAL HAZARD
• Someone could move or attempt to operate
the machine while it is unattended.
WHAT CAN HAPPEN
• Children or bystanders may be injured if
they use the machine.
HOW TO AVOID THE HAZARD
• Always remove the ignition key when
leaving the machine, even if just for a few
minutes.