Operator's Manual

Maintenance
28
2
1
m-4597
Figure 21
1. Rear access cover 2. Locking tabs
4. When finished, close the rear access cover by
swinging it up and seating it in place. Secure it
with the two locking tabs.
Greasing the T raction Unit
Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine.
Remove the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting
(Fig 22 and 23).
m–4396
Figure 22
m–4056
Figure 23
4. Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
5. Wipe up any excess grease.
Servicing the Air Cleaner
Clean the primary filter every 25 operating hours.
Replace the primary and secondary filter yearly.
Note: Service the air cleaner more frequently
if operating conditions are extremely
dusty or sandy.