Service Manual

CHAIN DRIVE/HYDRAULICS
4/2-32 Toro Wheeled CUL Service Manual
3. Position the auxiliary bracket over the handle and
onto the auxiliary valve (Fig. 0651).
4. Install the straight tting into the auxiliary valve (Fig.
0652).
5. Loosely install the selector valve onto the straight
tting (Fig. 0653).
Note: Do not tighten at this point. You may need to
adjust the spacing between the two valves to
match the mounting holes on the machine.
Fig. 0651 PICT-9959a
Fig. 0652 PICT-9972a
Fig. 0653 PICT-9973a
6. Before installing the valves to the upper frame,
notice the two different size spacers used on the
valves. The two short spacers are used on the
auxiliary valve (A) and the two longer spacers are
used on the selector valve (B) (Fig. 0654).
Fig. 0654 PICT-9976a
A B