Operator's Manual

22
2. Swing the rear access cover to the right (Fig. 20).
m–4670
Figure 20
Closing the Rear Access Cover
1. Swing the rear access cover to the left and seat it in
place over the back of the traction unit.
2. Place the latch over the locking bracket (Fig. 20).
3. Pull the latch rearward and push it in to lock it in place
(Fig. 20).
Removing a Side Screen
1. Open the hood.
2. Pull out and turn the two locking tabs on the inside of
the side screen until they line up with the slots in the
screen (Fig. 21).
m–4738
2
1
1
Figure 21
1. Side screen 2. Locking tab
3. Slide the screen inward, off of the tabs and pull it up
and out of the engine compartment.
Installing a Side Screen
1. Slide the screen into the engine compartment and line
up the holes in the bottom of the screen with the
rubber posts in the traction unit frame.
2. Push the screen firmly down over the rubber posts.
3. Slide the slots in the screen over the locking tabs
(Fig. 21).
4. Turn the tabs and fold them down to lock the screen in
place (Fig. 21).
Removing the Front Screen
If the engine has been running the heat shield will
be very hot and could burn you.
Allow the traction unit cool completely before
touching the heat shield.
Caution
1. Open the hood and remove both side screens.
2. Loosen the bolts securing the front weight (Fig. 22).
m-5236
2
1
3
4
Figure 22
1. Front weight
2. Bolts
3. Heat shield
4. Carriage bolts
3. Remove the carriage bolts and nuts securing the heat
shield (Fig. 22).
4. Lift the heat shield up and off of the traction unit.
5. Remove the 4 bolts securing the front screen to the
traction unit frame and remove the front screen
(Fig. 23).
2
1
m-5239
Figure 23
1. Front screen 2. Bolts (left side bolt not
shown)
6. Remove the shoulder bolts, double washer, and nuts
securing the oil cooler to the top of the front screen
(Fig. 24).